Abstract:In this paper, a two-dimensional steady-state theoretical model was established, to model the internal transport phenomena in a polymeric electrolyte membrane-based (PEM-based) air dehumidification element. The influences of electrochemical reactions, activation and concentration over-potentials, and Ohmic and electro-osmotic effects were considered. The model was solved by the finite difference method with conjugate boundary conditions. So, with this model, the heat, mass and current transfer through the five layers of the element (diffusion layers, catalyst layers and a PEM) could be described theoretically, as well as the convective heat and mass exchange with adjacent airflows. Compared with the results from previous models, this model showed a much closer trend to the experimental data. The overall error was less than 15%, with an acceptable average error of 8.6%. However, greater deviations were observed under larger airflow conditions, probably due to the assumption of laminar airflow and steady-state heat conduction. Furthermore, by the performance analysis, the maximum moisture gradient was found inside the PEM, so the PEM’s parameters could largely affect the system performance. With the increase in PEM water content, the dehumidification was significantly enhanced, especially when the air humidity was high. If the PEM water content was doubled, the dehumidification rate was increased by 42%. Then, decreasing the PEM thickness also improved the performance. However, the effect became minor if the thickness was less than 100 μm. It was also helpful by increasing the PEM conductivity, although the effect of this variable was relatively small. This study provided theoretical guidance for further system improvement and material preparation for PEM-based dehumidification systems.

Performance Analyzing Model for Fuel Cell System Enthalpy Wheel Humidifier

Heat and Mass Transfer Performance Study on Fuel Cell System Membrane Humidifier

Comparative Study of Membrane Humidifier and Enthalpy Wheel Humidifier for Large Power Fuel Cell System

Heat Transfer of Batch Simulating Continuous Fluidized Bed with Wet Particles

A Simulation Study of Heat and Mass Transfer in A Honeycombed Rotary Desiccant Dehumidifier

The performance of air membrane humidification system for PEMFC

Analysis of air humidification process for humid air turbine cycle with a detailed air humidifier model

Analysis of Heat and Mass Exchange Performance of Enthalpy Recovery Wheel

A Study on the Performance of New Air Humidification System for Fuel Cell Engine

Experimental and Numerical Analysis on Heat and Moisture Recovery Performance of Enthalpy Wheel with Condensation

Modeling mass and heat transfer in membrane humidifiers for polymer electrolyte membrane fuel cells

Modelling of Humidity Dynamics for Open-Cathode Proton Exchange Membrane Fuel Cell

Numerical and experimental analysis on air/water direct contact heat and mass transfer in the humidifier

Experimental and Numerical Analysis on Total Heat Recovery Performance of an Enthalpy Wheel under High Temperature High Humidity Working Conditions

A single-phase, non-isothermal model for PEM fuel cells

Analysis of Optimal Humidification Characteristics about PEMFC

Comparison of Self-Humidification Effect on Polymer Electrolyte Membrane Fuel Cell with Anodic and Cathodic Exhaust Gas Recirculation

Heat and mass transfer in a polymeric electrolyte membrane-based electrochemical air dehumidification system: Model development and performance analysis

A Lumped-Mass Model of Membrane Humidifier for PEMFC

Analysis of Water Management in Proton Exchange Membrane Fuel Cells

Investigation of heat and mass transfer and gas–liquid thermodynamic process paths in a humidifier