Abstract:To achieve energy efficiency and lower carbon emissions, building envelopes have become tighter and more insulated. These buildings must have mechanical ventilation with high efficient heat recovery to provide adequate indoor air quality using low energy in cold climates, and requirements for heat recovery efficiency are expected to increase. Today’s aluminum heat wheels, one of the most commonly used heat recovery systems, may not be capable of providing such a high efficiency due to the presence of longitudinal heat conduction. This study focuses on developing highly efficient heat wheels by reducing the longitudinal heat conduction and enhancing heat transfer in different channel shapes and matrix materials for heat wheels. Previously often neglected, but in large heat wheels, the longitudinal heat conduction can result in a significant efficiency reduction effect. The highly efficient heat wheels are sought via parametric analysis, experimental verification, and optimization in this study. Reducing matrix wall thickness for high conductive materials and using low conductive materials can significantly improve temperature efficiency. The calculated and experimental results show that the developed plastic and stainless steel heat wheels can exhibit high temperature efficiency of over 90% with acceptable pressure drops. However, stainless steel's high cost and stiffness may limit its use in heat wheels. Wheels made of plastic with circular channels that are symmetrical could be a promising solution to meet the high temperature efficiency needs of the future. Additionally, the optimization shows that the temperature efficiency of plastic heat wheels is more sensitive to design parameters than aluminum or stainless-steel wheels.

Experimental and Numerical Analysis on Total Heat Recovery Performance of an Enthalpy Wheel under High Temperature High Humidity Working Conditions

Experimental and Numerical Analysis on Heat and Moisture Recovery Performance of Enthalpy Wheel with Condensation

Analysis of Heat and Mass Exchange Performance of Enthalpy Recovery Wheel

Performance Comparison of Different Total Heat Exchangers Applied for Waste Heat Recovery

Performance comparison between enthalpy recovery wheels and dehumidification wheels

Numerical and Experimental Study on Performance of a Low-Backpressure Polyhedral Thermoelectric Generator for Waste Heat Recovery

Performance Comparison of Enthalpy Recovery Devices Using Liquid Desiccant and Desiccant Wheel

Frost Prevention Research of the Enthalpy Wheel in Air Conditioning Systems and Industrial Heat Recovery Systems

Novel Flue Gas Waste Heat Recovery System Equipped with Enthalpy Wheel

A Simulation Study of Heat and Mass Transfer in A Honeycombed Rotary Desiccant Dehumidifier

Irreversible Processes and Performance Improvement of Desiccant Wheel Dehumidification and Cooling Systems Using Exergy

Energy and Exergy Study on Indirect Evaporative Cooler Used in Exhaust Air Heat Recovery

Energy Saving Analysis On Heat Recovery In Wheel System Based On Life Cycle Cost

Development and optimization of highly efficient heat recoveries for low carbon residential buildings

Numerical simulation of characteristics of enthalpy recovery wheel with different desiccants

Enhancing Exergy Performance: Addressing Air Parameters Nonuniformity at the Outlet Cross-Section in Desiccant Wheel Air-Conditioning

Integrating Engine Thermal Management into Waste Heat Recovery under Steady-State Design and Dynamic Off-Design Conditions

Simulation of Scroll Expander Used in Low-Temperature Waste Heat Recovery System

Experimental and numerical study on low temperature regeneration desiccant wheel: Parameter analysis with a comprehensive energy index

Thermodynamic analysis of desiccant wheel coupled to high-temperature heat pump system

OPTIMIZATION ANALYSIS ON ENTHALPY RECOVERY DEVICE USING LIQUID DESICCANT