Abstract:In view of the limitations of the current code based on the equivalent beam-column method with the “rod mode” instead of the “arch mode” for the calculation of concrete-filled steel tube arch bridges, this paper takes the real bearing mechanism of the arch as the starting point and analyzes the different bearing mechanisms of the arch and eccentric pressurized column. The concrete-filled steel tube arch model test was carried out to analyze the deformation state and damage mode, and the geometric non-linear bending moment of the measured arch was compared with the bending moment value calculated by the eccentricity increase coefficient of the “rod mode.” The results showed that the transfer of internal force is from the axial force to the arch axis, causing the vertical reaction force and horizontal thrust. However, the eccentric compression column only produced the vertical force at the bottom and combines with the lateral deformation indirectly generated by the eccentric distance. In addition, the deformation stage of the arch is basically the same as that of the eccentric compression column. The final failure mode of the arch is 4-hinge damage, and the final failure mode of the eccentric compression column is single-hinge damage. The preliminary geometric non-linear bending moment value obtained by the two modes accords well. Therefore, the main factors for the difference in the bearing mechanism between the two modes are different force structures, force transmission routes, and sources of deformation. Due to the difference in the bearing mechanism, the final failure mode is different, and the deformation ability of the arch is weakened by using the “rod mode” instead of the “arch mode.” The geometric non-linear bending moment of the control section calculated by the eccentricity increase coefficient is conservative, but the influence of the geometric non-linearity of other sections is not considered enough.

Experimental Analysis of the Lateral Distribution Law of the Concrete Three-Ribbed Arch Bridges

Case Study on Stability Performance of Asymmetric Steel Arch Bridge with Inclined Arch Ribs

Numerical Analysis of Ultimate Strength of Concrete Filled Steel Tubular Arch Bridges

Study on Space Stress Characteristic and Carrying Capacity of Butterfly Arch

Damage Characteristics of Thin-Walled Steel Arch Bridges Subjected to In-Plane Earthquake Action

THEORETICAL STUDY ON THE IMPACT FACTOR OF CRESCENT-SHAPED MULTI-RIB CONCRETE FILLED STEEL TUBE TRUSS ARCH BRIDGES

Approach for Analyzing the Ultimate Strength of Concrete Filled Steel Tubular Arch Bridges with Stiffening Girder

Finite-element Analysis for Nonlinear Stabilities of Concrete-filled Steel Tubular Arch Bridges

Experimental Investigation of X-joint in Double-Arch Structure

Parametric Study of In-Plane Ultimate Bearing Capacity of CFST Truss Rib Arch Bridge

Stress Performance Analysis of Special-shaped Arch Bridge with Longitudinal Linkage

Reinforced Concrete Multi-Rib Arch Bridge Strengthened by Changing Structural System

Flexural behavior of reinforced concrete arch ribs

Multi-rib Arch Bridge Strengthened by Stayed-Cable and Field Test

Calculating Method and Experimental Research on Lateral Load Distribution of Transversely Strengthened Hollow Slab Bridge

Experimental and numerical study of the three-dimensional temperature field in the arch ribs of the reinforced concrete ribbed arch bridge during construction

Behaviour Analysis of Prestressed Concrete Deck-Tied Arch Bridge

Calculation model of concrete-filled steel tube arch bridges based on the “arch effect”

Study on Finite Element Analysis of Arch Dam by Deformation Assumptions Based on of Arch-beam Load-distributed Method

Experimental Investigation into Flexural-Torsional Ultimate Resistance of Steel Circular Arches

Strength Optimisation and Static Performance Analysis of Arch Ribs of Steel-tube Concrete Arch Bridge