Abstract:To study the dynamic mechanical properties and failure characteristics of intersecting jointed rock masses with different joint distributions under confining pressure, considering the cross angle α and joint persistence ratio η , a numerical model of the biaxial Hopkinson bar test system was established using the finite element method–discrete-element model coupling method. The validity of the model was verified by comparing and analyzing it in conjunction with laboratory test results. Dynamics-static combined impact tests were conducted on specimens under various conditions to investigate the strength characteristics and patterns of crack initiation and expansion. The study revealed the predominant factors influencing intersecting joints with different angles and penetrations under impact loading. The results show that the peak stress of the specimens decreases first and then increases with the increase of the cross angle. When α < 60°, regardless of the value of η , the dynamic stress of the specimens is controlled by the main joint. When α ≥ 60°, the peak stress borne by the specimens decreases with increasing η . When α < 60°, the initiation and propagation of cracks in the cross-jointed specimens are mainly controlled by the main joint, and the final failure surface of the specimens is composed of the main joint and wing cracks. When α ≥ 60° or η ≥ 0.67, the secondary joint guides the expansion of the wing cracks, and multiple failure surfaces composed of main and secondary joints, wing cracks, and co-planar cracks are formed. Increasing lateral confinement significantly increases the dynamic peak stress able to be borne by the specimens. Under triaxial conditions, the degree of failure of the intersecting jointed specimens is much lower than that under uniaxial and biaxial conditions.

Validity of one-dimensional experimental principle for flat specimen in bar–bar tensile impact apparatus

A TWO-DIMENSIONAL AXISYMMETRIC NUMERICAL ANALYSIS OF A BAR–BAR TENSILE IMPACT APPARATUS BY ELASTOPLASTIC FEM

A complete three-dimensional finite element analysis of the bar-bar tensile impact apparatus

3-D Dynamic Elastic–plastic FEA for Rotating Disk Indirect Bar–bar Tensile Impact Apparatus: Numerical Analysis for the Generation of Mechanically-Filtered Incident Stress Pulses

Comparative Study of 2D and 3D Micromechanical Discrete Element Modeling of Indirect Tensile Tests for Asphalt Mixtures

Tbiaxial Tension Test of Soft Materials

Dynamic Testing of Materials with the Rotating Disk Indirect Bar-Bar Tensile Impact Apparatus

Dynamic Simulation Analysis of the Mid-Strain-Rate Tensile Testing Machine

A New Specimen Fastener for Dynamic Tensile Testing Apparatus

Exploration of Related Problems Emerged in Impact Tension Experiment by Using Casing Hopkinson Bar

Experimental Study on the Dynamic J-Resistance Curve of Crack Growth of Elastic-Plastic Materials

On the Elastic Rod Models for Mechanical Tests of One-Dimensional Nanostructures under Transverse Loads

Bond Strength Prediction for Plain Bars under Lateral Tensile Compressive Stresses

Effect of the Geometric Shapes of Specimens on Impact Tensile Tests

One-dimensional stress-driven nonlocal integral model with bi-Helmholtz kernel: Close form solution and consistent size effect

Numerical Analysis of Effect of Specimen's Geometric Size and Bar's Material on Testing Result for CCCD-SHPB Dynamic Fracture Test System

A novel mechanical attachment for biaxial tensile test: Application to formability evaluation for DP590 at different temperatures

Three-dimensional numerical simulation of dynamic strength and failure mode of a rock mass with cross joints

Experimental Study on the Path of Crack Growth of Elastic-plastic Materials'Dynamic Fracture

Effect of Circumferentially Nonuniform Lateral Tension on Bond Behavior Between Plain Round Bars and Concrete: Analytical Study

Fundamental problem in optimizing the biaxial testing specimen