Abstract:Flexoelectric material under certain inhomogeneous electric field can be utilized to control the vibration of flexible structure based on the converse flexoelectric effect. The atomic force microscope (AFM) probe placed on the top of flexoelectric patch and the electrode under it with certain voltage applied between them are used to generate the inhomogeneous electric field. The actuation membrane force and bending moment induced by flexoelectric patch in turn influence the vibration of shells. In this study, an elastic cantilever beam excited by an initial static mechanical force locating at the tip end is considered. As the mechanical force withdraws the snapback response appears where the cantilever beam vibrates with all mode participating and their amplitudes decaying exponentially. Multiple actuators, consist of AFM probes and flexoelectric patches, are used here to accelerate the decrease of snapback response. On each probe voltages of multiple frequencies are applied to obtain the control effects on multiple modes. The actuator’s positions minimizing the tip displacement of the beam is selected as the optimal ones. Two way of determining the control voltage, i.e., open loop and close loop, is introduced and the information of positions of the actuators are emphasized in both methods. In case studies, the free damping vibration of the beam without control is evaluated and the first mode dominates the vibration. The open loop method, with constant amplitude of control voltage, doesn’t work well in a relatively long time scale. While the close loop method, with its control voltage related to the tip displacement detected by a sensor, turns out to be more stable and effective. The optimal positions for the actuations of both methods are clustered near the fixed end, where the actuation factor reaches its maximal value. At last, limitation on voltage amplitude is implemented to avoid the stress concentration, under which the control effect does not weaken much. This study serves as an introduction to flexoelectric material & multiple AFM probe based vibration control and a theoretical foundation for further researches.

Characteristic of Electromechanical Interaction of Mems Shuffling Actuator with Nonlinear Plate Electrode

Numerical analysis on snapping induced by electromechanical interaction of shuffling actuator with nonlinear plate

Macromodeling of the electrostatically actuated circular plate based on mode superposition method

Transient Pull-In Analysis of Micro-Plate with Fluid-Structure Interactions

RESEARCH ON PULL-IN AND RELEASE PHENOMENON OF ELECTROSTATIC MICROPUMPS

Macromodeling Of The Electrostatically Actuated Rectangle Plate Based On Modal Projection

Analysis on the driving characteristic of a shuffle MEMS

Multi-physics Analysis of an Electrostatically Actuated Microcantilever in Viscous Fluids

Mechanical Behavior Analysis on Electrostatically Actuated Rectangular Microplates

Distributed Multi-Flexoelectric Actuation and Control of Plates

Stability, Nonlinearity and Reliability of Electrostatically Actuated MEMS Devices

Influence of van der Waals Forces on Electrostatically Actuated MEMS/NEMS Circular Plates

Electromechanical Coupling Dynamic Modeling and Analysis of Vertical Electrodynamic Shaker Considering Low Frequency Lateral Vibration

Actuation of Flexoelectric Cylindrical Shell Panel with Line Electrodes

Control of Beam’s Snapback Responses Using Multiple Flexoelectric Actuators

Modeling of Electrostatically Actuated Microplates

Unstable Electrical Contact Behaviors At Nanoscale For Mems Switch

Investigation of Bistable Behaviour of Initially Curved Rectangular Microplates

A Reduced-Order Model for Electrically Actuated Microplates

Experimental analysis of a low controlling voltage tri-electrode MEMS electrostatic actuator for array applications

SNAP-THROUGH AND PULL-IN BEHAVIORS OF MEMS DEVICES WITH THE INITIAL CONFIGURATIONS