Abstract:Flexoelectric material under certain inhomogeneous electric field can be utilized to control the vibration of flexible structure based on the converse flexoelectric effect. The atomic force microscope (AFM) probe placed on the top of flexoelectric patch and the electrode under it with certain voltage applied between them are used to generate the inhomogeneous electric field. The actuation membrane force and bending moment induced by flexoelectric patch in turn influence the vibration of shells. In this study, an elastic cantilever beam excited by an initial static mechanical force locating at the tip end is considered. As the mechanical force withdraws the snapback response appears where the cantilever beam vibrates with all mode participating and their amplitudes decaying exponentially. Multiple actuators, consist of AFM probes and flexoelectric patches, are used here to accelerate the decrease of snapback response. On each probe voltages of multiple frequencies are applied to obtain the control effects on multiple modes. The actuator’s positions minimizing the tip displacement of the beam is selected as the optimal ones. Two way of determining the control voltage, i.e., open loop and close loop, is introduced and the information of positions of the actuators are emphasized in both methods. In case studies, the free damping vibration of the beam without control is evaluated and the first mode dominates the vibration. The open loop method, with constant amplitude of control voltage, doesn’t work well in a relatively long time scale. While the close loop method, with its control voltage related to the tip displacement detected by a sensor, turns out to be more stable and effective. The optimal positions for the actuations of both methods are clustered near the fixed end, where the actuation factor reaches its maximal value. At last, limitation on voltage amplitude is implemented to avoid the stress concentration, under which the control effect does not weaken much. This study serves as an introduction to flexoelectric material & multiple AFM probe based vibration control and a theoretical foundation for further researches.

Numerical analysis on snapping induced by electromechanical interaction of shuffling actuator with nonlinear plate

Characteristic of Electromechanical Interaction of Mems Shuffling Actuator with Nonlinear Plate Electrode

Transient Pull-In Analysis of Micro-Plate with Fluid-Structure Interactions

Macromodeling of the electrostatically actuated circular plate based on mode superposition method

Macromodeling of Electrostatically Actuated Circular Plate Based on mode analysis

Macromodeling Of The Electrostatically Actuated Rectangle Plate Based On Modal Projection

Multi-physics Analysis of an Electrostatically Actuated Microcantilever in Viscous Fluids

Analysis on the driving characteristic of a shuffle MEMS

Mechanical Behavior Analysis on Electrostatically Actuated Rectangular Microplates

Control of Beam’s Snapback Responses Using Multiple Flexoelectric Actuators

Finite Difference Based Electrical Modeling and Vibration Control Simulation of Piezoelectric Structronic Plate System

Electromechanical Coupling Dynamic Modeling and Analysis of Vertical Electrodynamic Shaker Considering Low Frequency Lateral Vibration

Dynamics and Active Control of Largely Deflected Active Structures Using the Finite Element Technique

Distributed Multi-Flexoelectric Actuation and Control of Plates

Numerical Modeling of a Damaged Plate with Piezoelectric Actuation

Method to Control Dynamic Snap-Through Instability of Dielectric Elastomers

Influence of van der Waals Forces on Electrostatically Actuated MEMS/NEMS Circular Plates

Analysis on the Magneto-Elastic-plastic Buckling/snapping of Cantilever Rectangular Ferromagnetic Plates

Dramatic amplification of the flexoelectric effect in snapping surfaces

Dynamic Analysis For Electrified Cantilever Conductive Thin Plates Under Transverse Multi-Pulse Magnetic Field

SNAP-THROUGH AND PULL-IN BEHAVIORS OF MEMS DEVICES WITH THE INITIAL CONFIGURATIONS