Abstract:The leakage flow characteristics of the variable bristle diameter (VBD) brush seals are numerically investigated using the three-dimensional (3D) tube bundle model with consideration of bristle pack stratification. The discretization of the computational domain applies the multiblock structured mesh, which ensures that there is no need to set interfaces between the fluid domains of the bristle pack and the cavities to eliminate interpolation errors. The bristle pack stratification is achieved by using mesh motion technique from the point of cause-effect. The effects of pressure ratio ( Rp=1.5,2.5,3.5), axial rows of bristles ( Nx=9-21), sealing clearance ( c=0,0.1mm), bristle pack arrangements, and bristles gapping ( gi=0,0.005,0.010,0.015mm) on the leakage flow characteristics and aerodynamic forces are conducted. The recorded leakage flow of the 3D tube bundle model is multiplied by circumferential loop number ( Ncl) to determine total leakage flow rate of the brush seal. The numerical results agreed well with the experimental data, which verifies the reliability of the numerical method. The numerical results indicate that the leakage flow rate increases linearly with the pressure ratio. The increase of Nx has a distinctly different effect on the relative rate of leakage flow for the contacting and clearance brush seals. The use of large diameter bristles weakens the sealing performance of the brush seals, particularly in the rear region. Bristle pack stratification can improve the sealing performance of the brush seals. The large diameter bristles increase the porosity and reduce the flow resistance coefficients. On the contrary, the bristle pack stratification decreases the porosity and rises the flow resistance coefficients in the rear region. The results of this article indicate when designing VBD brush seals, the effects of bristle diameter and bristle density on the sealing performance and pressure loading capacity of the brush seals should be fully considered.

Numerical Investigation into Bristle-Rotor Contact Force of Brush Seals

Analytical Investigations on the Contact Force Between Bristle Packs and Shaft Surface of Brush Seals

Numerical Investigations on the Hysteresis Characteristics of Brush Seals

Theoretical and Experimental Investigation on Tip Forces and Temperature Distributions of the Brush Seal Coupled Aerodynamic Force

Numerical investigations on the heat transfer behavior of brush seals using combined computational fluid dynamics and finite element method

Numerical Investigations on Influence Factors of Leakage Flow and Heat Transfer Characteristics of Brush Seal

Investigations on the heat transfer characteristics of brush seals based on computational fluid dynamics and finite element analysis

Study on Model of Continuous Rotor under Steam Seal Force

Modeling a Two-Span Rotor System Based on the Hamilton Principle and Rotor Dynamic Behavior Analysis

Numerical Analysis Of Dynamic Coefficients In Brush Seal

Numerical research on contact friction force with different structural brush seal hysteresis characteristics under differential pressure

Numerical analysis of brush seal hysteresis based on orthogonal test method

Flows in Brush Seals Based on a 2-D Staggered Tube Bundle Model

Structural dynamic characteristics of brush seals in aeroengine

Wear and Leakage Behaviors of Brush Seal Considering Eccentricity and Radial Deformation

Investigation of Friction Characteristics of Brush Seal with Bulk Porous Medium Approach

NUMERICAL AND EXPERIMENTAL INVESTIGATIONS ON THE LEAKAGE FLOW CHARACTERISTICS AND TEMPERATURE DISTRIBUTIONS OF BRUSH SEALS

Using a Three-Dimensional Tube Bundle Model to Investigate the Leakage Flow Characteristics of the Rotating Brush Seal

A Three-Dimensional Tube Bundle Model Analysis for Leakage Flow Characteristics of Variable Bristle Diameter Brush Seals with Bristle Pack Stratification

Numerical Investigations on the Leakage Flow Characteristics of Brush Seal Based on the Three-Dimensional Staggered Tube Bundle Model

Investigation of Conjugate Heat Transfer in Brush Seals Using Porous Media Approach under Local Thermal Non-Equilibrium Conditions