Abstract:As HDS catalysts, the supported catalysts including oxide state Mo, Co–Mo and sulfide state Mo on carbon nanotube (CNT) were prepared, while the corresponding supported catalysts on γ-Al2O3 were prepared as comparison. Firstly, the dispersion of the active phase and loading capacity of Mo species on CNT was studied by XRD and the reducibility properties of Co–Mo catalysts in oxide state over CNTs were investigated by TPR while the sulfide Co–Mo/CNT catalysts were characterized by XRD and LRS techniques. Secondly, the activity and selectivity of hydrodesulfurization (HDS) of dibenzothiophene with Co–Mo/CNT and Co–Mo/γ-Al2O3 were studied. It has been found that the main active molybdenum species in the oxide state MoO3/CNT catalysts were MoO2, rather than MoO3 as generally expected. The maximum loading before formation of the bulk phase was lower than 6%m (calculated in MoO3). The TPR studies revealed that that active species in oxide state Co–Mo/CNT catalysts were more easily reduced at relatively lower temperatures in comparison to those in Co–Mo/γ-Al2O3, indicating that the CNT support promoted the reduction of active species. Among 0–1.0 Co/Mo atomic ratio on Co–Mo/CNT, 0.7 has the highest reducibility. It shows that the Co/Mo atomic ratio has a great effect on the reducibility of active species on CNT and their HDS activities and that the incorporation of cobalt improved the dispersion of molybdenum species on CNT and mobilization. It was also found that re-dispersion could occur during the sulfiding process, resulting in low valence state Mo3S4 and Co–MoS2.17 active phases. The HDS of DBT showed that Co–Mo/CNT catalysts were more active than Co–Mo/γ-Al2O3 and the hydrogenolysis/hydrogenation selectivity of Co–Mo/CNT catalyst was also much higher than Co–Mo/γ-Al2O3. For the Co–Mo/CNT catalysis system, the catalyst with Co/Mo atomic ratio of 0.7 showed the highest activity, whereas, the catalyst with Co/Mo atomic ratio of 0.35 was of the highest selectivity.

Mössbauer Study of Catalytically Grown Carbon Nanotube

Mössbauer Study on the Conversion of Different Iron-Based Catalysts Used in Carbon Nanotube Synthesis

Growth of Carbon Nanotubules on Fe-loading Zeolites and Investigation of Catalytic Active Center

A New Understanding of Carbon Nanotube Growth: Activation and Deactivation of a Catalyst

Thin-Film Metal Catalyst For The Production Of Multi-Wall And Single-Wall Carbon Nanotubes

In Situ Study of Carbon Nanotube Formation by C2H2 Decomposition on an Iron-Based Catalyst

Influence of Co Oxidation States on Carbon Nanotubes Growth over Co/Mo/MgO

In Situ TEM Observation of the Gasification and Growth of Carbon Nanotubes Using Iron Catalysts

Influence of Cerium Metal As Catalyst on the Growth and Structure of Single-Walled Carbon Nanotubes

Catalytic effect of the spinel ferrite nanocrystals on the growth of carbon nanotubes

Influence of Mo on the Fe:Mo:C nano-catalyst thermodynamics for single-walled carbon nanotube growth

Carbon-Involved Near-Surface Evolution of Cobalt Nanocatalysts: an in Situ Study

FT-IR Study of Carbon Nanotube Supported CoMo Catalysts

Comparison study of catalyst nanoparticle formation and carbon nanotube growth: Support effect

Effect of adding nickel to iron–alumina catalysts on the morphology of as-grown carbon nanotubes

Thermogravimetric analysis and TEM characterization of the oxidation and defect sites of carbon nanotubes synthesized by CVD of methane

Carbon-supported Iron Catalysts: Iron-57 Mössbauer Spectroscopic Studies of Phase Formation and Dispersion Properties Which Influence Catalytic Performance

XPS Characterization of Carbon Nanotube Supported CoMo Hydrodesulfurization Catalysts

Single wall carbon nanotubes growth over cobalt-iron mesoporous MCM-41 bimetallic catalyst under methane chemical vapor deposition, an experimental and DFT evaluation

How reduction temperature affects the properites of carbon nanotubes growing over Fe-MgO/Al2O3 catalyst

States of Carbon Nanotube Supported Mo-Based HDS Catalysts