Abstract:The ultrahigh static displacement-acceleration sensitivity of a mechanical sensing chip is essential primarily for an ultra-sensitive accelerometer. In this paper, an optimal design to implement to a single-axis MOEMS accelerometer consisting of a grating interferometry cavity and a micromachined sensing chip is presented. The micromachined sensing chip is composed of a proof mass along with its mechanical cantilever suspension and substrate. The dimensional parameters of the sensing chip, including the length, width, thickness and position of the cantilevers are evaluated and optimized both analytically and by finite-element-method (FEM) simulation to yield an unprecedented acceleration-displacement sensitivity. Compared with one of the most sensitive single-axis MOEMS accelerometers reported in the literature, the optimal mechanical design can yield a profound sensitivity improvement with an equal footprint area, specifically, 200% improvement in displacement-acceleration sensitivity with moderate resonant frequency and dynamic range. The modified design was microfabricated, packaged with the grating interferometry cavity and tested. The experimental results demonstrate that the MOEMS accelerometer with modified design can achieve the acceleration-displacement sensitivity of about 150 mu m/g and acceleration sensitivity of greater than 1500V/g, which validates the effectiveness of the optimal design.

Silicon Micro-Accelerometer with Mg Resolution, High Linearity and Large Frequency Bandwidth Fabricated with Two Mask Bulk Process

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

Laterally Capacity Sensed Accelerometer Fabricated with the Anodic Bonding and the High Aspect Ratio Etching

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

High Resolution Single Crystal Silicon Accelerometer Using Silicon Fusion Bonding and Deep Reactive Ion Etching

A silicon-on-glass Z-axis accelerometer with vertical sensing comb capacitors.

High-Performance Single-Side Fabricated (111)-Silicon Dual-Cantilever Accelerometer with Squeeze-Film Air Damping Modulation

A novel capacitive accelerometer with an eight-beam-mass structure by self-stop anisotropic etching of (1 0 0) silicon

A micromachined silicon resonant accelerometer

A Bulk Micromachined Si-on-glass Tunneling Accelerometer with Out-of-plane Sensing Capability

Micromachined Interferometric Accelerometer Fabricated Using SGADER Process

Design and Fabrication of a Micro-Electromechanical System Sandwich Capacitive Accelerometer

A silicon micromachined high-shock accelerometer with a bonded hinge structure

Design and Virtual Fabrication Process of a New Kind of Capacitive Accelerometer

Design and Test of a Micromachined Resonant Accelerometer with High Scale Factor and Low Noise

A Bulk Micromachined Si-on-Glass Tunneling Accelerometer

A Wafer Level Vacuum Encapsulated Capacitive Accelerometer Fabricated in an Unmodified Commercial MEMS Process

A Novel Hinged Micromachined High-G Piezoresistive Accelerometer

A MEMS Sandwich Differential Capacitive Silicon-on-insulator Accelerometer

Design and Fabrication Research on a Capacitive Accelerometer