Abstract:Small animal PET scanners need to have a high spatial resolution since the size of the organs of small animals is much smaller than that of humans, and also need to have a high sensitivity since the allowed injection dose is limited by the radiation dosimetry of the small organs. To simultaneously achieve high spatial resolution and high sensitivity for a small animal PET scanner, detectors with high position resolution, high efficiency and high depth of interaction (DOI) resolution are required. In this work, three 17 x 17 pixelated LYSO arrays with crystal size of similar to 0.5 mm and an outer dimension of 10 x 10 x 20 mm(3) are fabricated. The first LYSO array uses 80 mu m thick BaSO4 reflector. The second and the third LYSO arrays use 65 mu m thick Toray reflectors. The outermost side of the third LYSO array is also wrapped with k9 glass of the same size as the crystals in the array in order to improve the light collection and flood histogram quality for the edge crystals. The LYSO arrays are read out with two Hamamatsu SiPM arrays from both ends. The SiPM array is 4 x 4, with 3 x 3 mm(2) pixel size and 0.2 mm gap in between the SiPM pixels. The SiPM array is read out with a resistor network circuit to reduce the number of signals from 16 to 4. The performance of the detector in terms of flood histograms, energy resolution, DOI resolution and timing resolution was measured. All three detectors provide good flood histograms and all crystals in an array can be clearly resolved. The average DOI resolutions of individual crystals are 1.84, 1.98 and 1.93 mm for the three detectors for events with energy E > 350 keV. The BaSO4 array has higher light output and provides a better average crystal energy resolution of 21.0 %. The photopeak amplitude of the Toray arrays changes with depth, which results in worse energy resolutions of 24.4 % and 23.8 % for the two detectors respectively. The average timing resolutions of individual crystals are 1.23, 1.27 and 1.24 ns for the three detectors for events with E > 350 keV. All three detector modules achieved high position resolution (0.5 mm crystal size), high efficiency (20 mm crystal length) and high DOI resolution (<2.0 mm) and can be used to build a high sensitivity small animal PET scanner with spatial resolution approaching the physical limit.

The Design of a X-ray Array Detector with 0.4mm Pixel

Design Realization and Characterization of A Position Sensitive Detector for Fast Optical Measurement

X-ray Sensor Based on Pixelated Scintillation Film on Photodiode Arrays

Fabrication and Characterization of a New Type 4×4 Arrayed Position-Sensitive Detector

Fabrication and characterization of a new type 4 × 4 arrayed position sensitive detector

Design the of X-ray Backscatter Array Detector Based on SiPM

Design of Solid-State Detector Modules for High Energy X-ray Imaging

The Development and Evaluation of Solid-State Detector Arrays for High Energy X-Ray Imaging

Studies of A Solid Detector Array for High Energy X-Ray Imaging System Based on Ma-Pmt

Design of a Γ-Ray Imaging System for Plant Studies

Design And Development Of Novel And Practical Pet Detectors For Advanced Imaging Applications

Design and Development of a 3D Position-Sensitive Detector for 4π View Gamma Imager Based on Dual-Ended Readout Technique

Dual-ended Readout Small Animal PET Detector by Using 0.5 Mm Pixelated LYSO Crystal Arrays and SiPMs

Ga2O3 Photon‐Controlled Diode for Sensitive DUV/X‐Ray Detection and High‐Resolution Array Imaging Application

Design And Initial Performance Evaluation Of A Novel Pet Detector Module Based On Compact Sipm Arrays

High resolution, high efficiency liquid scintillator capillary array for gamma imaging

Performance Evaluation of a Modular Detector Unit for X-Ray Computed Tomography.

Design Of A High Resolution Phoswich Pet Detector

Design and Optimization of Direct-Conversion Photon-Counting Detector for Dual-Energy Ct Imaging

Development of 4×4 Pixel CdZnTe Detector