Research on Aerodynamic and Strength Performance of Last Stage in High-Pressure Cylinder of Steam Turbine under Variable Working Conditions
SHI Honghui,WANG Haibo,CAO Rongxiu,YAO Li,YAN Xin
DOI: https://doi.org/10.12096/j.2096-4528.pgt.21105
2022-01-01
Abstract:Using the one-way fluid-structure interaction method, the aerodynamic and strength performance of the last stages in high-pressure cylinder of a steam turbine were numerically investigated at four extraction percentages (0%, 8%, 15% and 20% of the total mass flow rate in stages). The aerodynamic efficiency of last stages, as well as the aerodynamic loads on the blades, was obtained under design and off-design conditions. With the computed aerodynamic loads, the strength performance of the last rotor blade was analyzed, and the maximum stress and deformation in rotor blade at various conditions were derived. The results show that the power output of last two stages is nearly linearly decreased with the increase of extraction percentage. If the extraction percentage equals to 20%, the power output is reduced by 44% as compared with the design case. As the extraction percentage increases, the total temperature at last stage outlet is gradually increased. With 20% extraction rate, the total temperature at last stage outlet is increased by about 10 ℃ compared with the design case. The extraction rate has a significant influence on the leakage performance in the tip and hub labyrinth seals of last stage, resulting in the variations of total-total isentropic efficiency, reaction degree and outlet flow angle distributions along the spanwise direction in the off-design conditions. The influence region in the last stage is mainly existed within 30% blade span near hubs due to varied extractions. Compared with the original design case, the total-total isentropic efficiency, reaction degree and outlet flow angle in the last stage are varied by 3.8%, 1.6% and 2.4° at most as the extraction percentage varies from 0 to 20%. With the centrifugal and aerodynamic forces, the maximum stress in the last stage rotor blade is occurred at the upstream side bottom fillet of T-shape root, and the maximum displacement in blade tip is 0.443 mm. As the extraction percentage increases, the maximum stress and maximum displacement in last stage rotor blade are almost linearly decreased.