Abstract:Abstract In this paper, the automatic measurement method of the Hydraulic Torque Converter shape parameters is studied. Aiming at the defects of the traditional manual measurement method, the solution for measuring the shape parameters of Hydraulic Torque Converter with the automatic measurement system is proposed on the basis of in-depth analysis for the Hydraulic Torque Converter shape parameters’ characteristics. Automatic measurement system mainly contains two parts, the Hardware Measurement System and the Software Measurement System. The working principle of the automatic measurement system are as follows: firstly, as system starting, the arm upper Measuring Fixture put the Hydraulic Torque Converter work piece into the Measuring Fixture, and then the Measuring Fixture make the Pump Hub Axle and Cover Hub Axle of the measured work piece fixed; secondly, the measured work piece start to rotate, at the same times, s the work piece is measured by MARPOSS displacement sensor. The measuring stop as soon as the measured work piece completes rotating 360 degrees. Lastly, measurement data is collects by the Software Measurement System based on LabVIEW development platform using NI acquisition card. The Moving Average Filter and Butterworth approximation method is mainly used during processing the measurement data. The tolerance measuring value of each shape parameter can be obtained, after the measurement data processed. The external dimensions of the measured work piece have been qualified by the data obtained. Under practical test, this method fit the industrial production demand very well; it can help to improve the production efficiency greatly used in the industrial production

Micro-torque Measurement and Analysis System

Signal Collection and Processing for Non-contact Automotive Torque Sensor

Automatic Control System for a Torque Converter Static and Cycle Hydraulic Tester

Cutting Temperature and Force Data Acquisition and Measuring System Design in High Speed Machining

The Design of Characteristic Testing System for GMA Based on LabVIEW

The Computer Control System Designing of a Kind of Automobile Driving Axis Roller Test Table

Multi-node data acquisition and analysis system for the development of AT electronic control unit.

Design of smart torque sensor based on LabVIEW

Instrument Designed for Measuring Electrical Parameters of Variable Frequency Motor Based on DSP

Design and Analyze of Power-measuring System for Mini-motor

A Novel Dynamic Power Dynamometer Based on PWM Rectifier and Direct Torque Control of Induction Machine

Research of System of Dynamic Torque Based on Virtual Instruments

An economical rapid control prototyping system design with MATLAB/Simulink and TMS320F2812 DSP

A Study on the Control System of AC Dynamometer

The Development of the AC Dynamometer System Based on PXI

Automatic Measurement Of Shape Parameters For Hydraulic Torque Converter

Development of the Measuring Instrument for Stiffness of Micro Torsion Bar

Detection of Actuator Friction Torque Based on Digital Filtering Techniques

CAN Interface Steering Wheel Angle and Torque Acquisition System with 16-Bit A/D Converter

Using a low-cost bluetooth torque sensor for vehicle jerk and transient torque measurement

Microchip Controlled Electronic Circuit for Measurement of the Angular Acceleration