Abstract:This paper aims to realize a self-reference delamination inspection in CFRPs with diffuse ultrasonic waves. The static experiments are first conducted on samples with a machined defect of 0.5 mm in height which simulates an opening state delamination. The diffusivity decreases with delamination diameter (pristine, 6 mm, 12 mm) at a constant depth and increases with delamination depth (0.25 mm, 0.75 mm) at a given diameter. However, no clear pattern can be found for the dissipation coefficient because of the intrinsic absorption and manufacturing uncertainties. Both coefficients are insensitive to the delamination height under loading. In contrast, the corresponding maximum cross-correlation coefficient from coda wave interferometry shows a variation of 2.4–7 % in different samples. A sharp transition can be found due to the clapping effect when the delamination is fully closed. After then, the static loading is replaced by acoustic stressing pulse from PZT in a closed delamination sample. The low frequency pulse induced reverberation field is sampled by a high frequency diffuse wave semi-synchronously, which mimics a cyclic and low amplitude loading during service. All the dynamic cross-correlation coefficient curves present an ascending trend during voltage ramp-up due to the viscoelastic effect, no matter in the intact zone or delamination zone. When the voltage threshold of 250 V is reached, the clapping effect can be triggered. A descending trend has been found not only when the excitation is right above but also near the delamination. This can be applied as an indicator of the delamination existence regionally without scanning. Such nonlinear measurement system can be expanded to passive imaging and other deficiency inspection in CFRPs with less demanding facilities.

Coating Evaluation Using Ultrasonic Wave Technology

Evaluation of Pipe Axial Defeat Through the Use of Ultrasonic Guided Wave and Matching Pursuit

Multi-Peak Fitting Analysis of Visible Raman Spectra on DLC Coatings Deposited by Vacuum Arc

A Novel High-Frequency Ultrasonic Approach for Evaluation of Homogeneity and Measurement of Sprayed Coating Thickness

Integration of diamond-like carbon and AlN for acoustic wave devices

An experimental technique for evaluating viscoelastic damping using ultrasonic guided waves

A Novel Technique for the Measurement of the Acoustic Properties of a Thin Linear-Viscoelastic Layer Using a Planar Ultrasonic Transducer

Simultaneous Measurement of Local Longitudinal and Transverse Wave Velocities, Attenuation, Density, and Thickness of Films by Using Point-Focus Ultrasonic Spectroscopy

Research on Ultrasonic Testing Methods for Adhesion Quality of Ceramic Coatings

Nondestructive evaluation with fully non-contact air-coupled transducer-scanning laser Doppler vibrometer Lamb wave system

Application of laser ultrasonic for detecting delamination in Cu/Al composites

Nondestructive measurement of the grain size of laser cladding coatings using a laser ultrasonic method

Viscoelastic characterization of coating layers by ultrasonic interference and critical attenuation

Characterization of Elastic Modulus of Laser Cladding Coatings Using Laser Ultrasonic Method

Static and dynamic diffuse wave inspection of delaminations in carbon fiber reinforced composites

Nonlinear Ultrasonic C-Scan Imaging for Contact-Type Defects in Diffusion-Bonded Joints—A Case Study

High-Resolution Ultrasonic Lamb Waves Dispersion Measurement and Plate Thickness Evaluation

Oblique-incidence Ultrasonic Testing for the Adhesion Quality of Ceramic Coatings

Evaluation of the Bond Quality of Metal-Clad Plates Using Laser Ultrasonic Local Resonance

Characterisation of Ultra-Thin DLC Coatings by SEM/EDX, AFM and Electrochemical Techniques

Non-Destructive Evaluation of Coating Thickness Using Water Immersion Ultrasonic Testing