Abstract:The 6××× series aluminum alloys Al-Mg-Si-Cu are widely used in the transportation and building industries due to their comprehensive mechanical properties, adequate formability, high corrosion resistance and good weldability. For decades, ultrafine grain structure (UFG) produced by severe plastic deformation (SPD) has been proved to be a promising way in strengthening Al alloy materials. Although this method can guarantee a great improvement in strength, the obtained ductility is always disappointing. Besides, this method has a limitation to fabricate products suitable for practical use. Recently, combining deformation and aging has been proposed to pro-duce high-strength Al alloys. This strategy is very effective in achieving Al alloys with strength-ductility synergy even through conventional producing process, for example, rolling and aging. The strain ratio of deformation is crit-ical in tuning the mechanical properties which could be acquired by the above method. The effect of deformation strain ratio on the age-hardening behaviors and microstructure in Al-Mg-Si-Cu alloy produced by combining cold-rolling and aging are investigated using hardness test, tensile test, EBSD and TEM in this work. The results show that the as-rolled hardness increases gradually with deformation strain ratio. The age-hardening potential declines with the increase of strain ratio, though post-aging could further strengthen the as-rolled alloys. The grains elongate along the rolling direction during deformation and finally have a lamellar structure. Fragmentation and extensive defects like sub-grain boundaries occurs inside the grains. The dislocations become denser inside the alloy with the increase of the deformation ratio. When the deformation ratio is large (above 60%), formation of dislocation tan-gling and sub-grains are observed. Deformation-induced change of the dislocation configuration affects the precipitation significantly. Due to the interaction between solutes precipitation and defects annihilation, the distribution of precipitates undergoes a change from being isolated to a continuous manner.

Structure and Strength after Large Strain Deformation

Achieving High Strength and High Ductility in Nanostructured Metals: Experiment and Modelling

Thermal Stability of Aluminum Cold Rolled to Large Strain

Strain Hardening under Large Deformation for AA5182

Microstructural Parameter-Based Characterization of Annealing Behaviour in Metals Deformed to High Strains

Large strain flow curve identification for sheet metals under complex stress states

A Model of Grain Refinement and Strengthening of Al Alloys Due to Cold Severe Plastic Deformation

Annealing Behavior of Nanostructured Aluminum Produced by Cold Rolling to Ultrahigh Strains

Microstructure and Mechanical Properties of Nickel Processed by Accumulative Roll Bonding

EFFECT OF PRE-DEFORMATION ON AGE- HARDENING AND MICROSTRUCTURE IN Al-Mg-Si-Cu ALLOY

Evolution of microstructural parameters and flow stresses toward limits in nickel deformed to ultra-high strains

Microstructure evolution, constitutive modeling and forming simulation of AA6063 aluminum alloy in hot deformation

Effect of second-phase precipitates on deformation microstructure in AA2024 (Al–Cu–Mg): dislocation substructures and stored energy

Microstructural evolution and strength of copper during cold rolling to large strain

Microstructure and Texture Evolutions of Aa1050 Aluminum Alloy Cold Rolled to High Strains

Ultrafine Structure and High Strength in Cold-Rolled Martensite

Effect of Severe Cold or Warm Deformation on Microstructure Evolution and Tensile Behavior of a 316L Stainless Steel

EBSD-Based Techniques for Characterization of Microstructural Restoration Processes During Annealing of Metals Deformed to Large Plastic Strains

Correlation Between Strength and Strain in Heavily Cold-rolled Commercial Purity Aluminum

Microstructure and flow stress of polycrystals and single crystals

Microstructural evolution and mechanical properties of accumulative roll bonded interstitial free steel