Abstract:In order to evaluate the performance of software and instruments,the assessment mean lines of roughness profiles are researched by means of Gaussian filtration,least square mean lines and the least square conic fitting on the basis of the software standard ISO 5436-2.And by simulating manufacturing process data,measuring EDM surface data and honing surface data,the typical roughness profile parameters Ra、Rq、Rp、Rv、Rsk、Rku defined in ISO 4287 are assessed and their deviation values from standard results are analyzed.Experimental results indicate that for the simulated process data,the results given by three kinds of mean lines are all better than those of the original ones,except the deviation value of Rsk is relatively bigger by 50% or so than that given by the least square method.For the EDM surface data,the deviation values given by the Gaussian filtration are smaller and those given by other two least square mean lines are a little bigger.The relatively bigger ones are Rsk with relative errors of 3.55% and-7.45% and Rp with relative errors of-3.45% and 3.95% respectively.For the honing surface data,the parameter deviation values are all bigger computed under three mean lines because of the jumping bump,and the deviation values of parameters Ra、Rq are relatively smaller,but the others are bigger.After excluding the jumping bump,the deviation values of Ra、Rq are still relatively smaller,those of Rsk and Rp are minishied from big to small,but those of Rku、Rp are still 40% or so.It can be concluded that the roughness parameters almost have no distinct difference based on the three mean lines for the profiles without jumping bump.Therefore,for the common precision profile without distinct periodical waveness components and bigger jumping bumps,the typical roughness parameters Ra、Rq can be assessed by the least square method which is simple and easy to be realized.

Assessment Mean Lines of Surface Texture Based on ISO5436-2

Survey of measurement methods for surface roughness

Surface Roughness Evaluation By Using Wavelets Analysis

Estimation of the joint roughness coefficient (JRC) of rock joints by vector similarity measures

Influence of Different Filtration Methods Application on a Filtered Surface Profile and Roughness Parameters

Analysis on Surface Texture Software Measurement Standards and Their Application

Comparison between ASME and ISO standards on surface texture

Roughness Analysis in Line-Contact Rotating-Milling Cylindrical Surface

Assessment of Ground Surface Roughness Based on Computer Vision Technology

Comparison Of Optical Surface Roughness Measured By Stylus Profiler, Afm And White Light Interferometer Using Power Spectral Density

A Robust Spline Filter Algorithm Based on M-Estimate Theory

Assessment on Surface Roughness Models Based on Semantics and Profile Characteristics Matching

Separation of Surface Roughness Profile from Raw Contour Based on Empirical Mode Decomposition

Specifying Surface Roughness of Optical Film Substrate Using the Power Spectral Density

Robustness of Surface Roughness against Low Number of Picture Elements and Its Benefit for Scaling Analysis

Application of Atomic Force Microscopy on the Nanometer Scale Surface Roughness Measurement

Development Of User-Friendly Software For The Roughness Measurement Of Ultra Smooth Surface

Comparison of surface roughness parameters Ra/Sa and Rz/Sz with different measuring devices

Surface Texture Partition and Parameters Evaluation Based on Gaussian Filter

Measurement of Device Surface Profile and Roughness

On-Line Surface Roughness Measurement Based On Specular Intensity Component Of Speckle Patterns