Abstract:With the rapid development of information technology, high-speed digital optical signal transmission technology has become the core of modern communication networks. However, the increase in transmission rates brings challenges such as noise, distortion, and interference, which affect the accuracy of clock recovery. To address these issues, this study proposes a clock recovery algorithm based on the eye diagram opening area to improve the accuracy and efficiency of high-speed digital optical signal jitter measurement. The proposed method extracts clock information from the signal using the opening area and curvature characteristics of the eye diagram for jitter measurement. Experimental results demonstrate that the clock recovery algorithm based on the eye diagram opening area can stably reconstruct the signal eye diagram and obtain jitter parameters under different optical power conditions. At optical powers of -7.2 dBm, -12.2 dBm, and -17.2 dBm, the Q-factors were 8.8, 7.6, and 4.3, respectively, and the RMS jitter values were 12.2 ps, 13.4 ps, and 21.2 ps, respectively. At optical powers of -2.3 dBm, 0.1 dBm, 2.4 dBm, 4.6 dBm, and 6.0 dBm, the Q-factors were 9.1, 9.3, 9.5, 9.7, and 10.0, respectively, and the average jitter values were 8.9 ps, 8.5 ps, 8.0 ps, 7.5 ps, and 7.0 ps. These results indicate that the proposed algorithm performs excellently under low optical power conditions and maintains high recovery accuracy even when jitter increases at higher optical powers. The clock recovery algorithm based on the eye diagram opening area significantly improves the accuracy and stability of high-speed digital optical signal jitter measurement, enriches the theoretical research of clock recovery algorithms, and shows significant advantages in improving signal transmission quality, reducing bit error rate, and enhancing communication link reliability. The research outcomes provide key technical support for the optimization of modern high-speed optical communication systems.

The Study and Analysis of Joint Adaptive Clock Recovery Mechanism for Tdmoip

Design and Implementation of Clock Recovery Algorithm in TDM-over-IP

Joint Adaptive Clock Recovery Mechanism for SAToIP and Performance Analysis

Clock Recovery and Audio/Video Synchronization in Digital TV System

Instant Recovery--a New Recovery Algorithm for TCP Congestion Control

Clock Recovery and Demultiplexing in Otdm Communication

Performance Analysis of Chip Tracking Loop Using TDRC Waveform Pseudo-Number Code

Optimization Of Symbol Timing Recovery For Dtmb Receivers

A Combined Code Acquisition and Symbol Timing Recovery Method for TDS-OFDM.

Study on Ajoint Multiple Layer Restoration Scheme for IP over WDM Networks

Timing Recovery for Point-to-Multi-Point Coherent Passive Optical Networks

WR-enhanced TDM-PON with nanosecond clock and data recovery and picosecond time synchronization

Resilient Clock Synchronization Architecture for Industrial Time-Sensitive Networking

Power and Area Efficient CMOS Clock Recovery Circuit for 10/100 Base-T Ethernet

Coding, Decoding, and Recovery of Clock Synchronization in Digital Multiplexing System.

Clock Recovery and Equalization Algorithms for Coherent Optical Communication Systems with Non-Integer Oversampling

Evaluation of a Subnanosecond Clock and Data Recovery Technique Via Matlab Simulink and Opti-System Co-Simulation

Research on high-speed digital optical signal jitter measurement technology based on clock recovery algorithm using eye diagram opening area

Recovery Time Analysis of A Distributed Redundancy Protocol

Clock Recovery for OTDM and 3R Regeneration

Dynamic stream partitioning for time-triggered traffic in Time-Sensitive Networking