Abstract:Time synchronization is crucial in many distributed acquisition systems, such as structural health monitoring systems and vibration-based condition monitoring. To achieve high synchronization accuracy, proactive synchronized sampling based on a hardware clock is often adopted. However, it is difficult to compensate the drift of the hardware clock, which makes the synchronization accuracy worse. In this paper, a clock drift compensation method for a hardware clock is proposed. Essentially, a mathematical model is constructed to describe the interactions between the synchronization error and clock tick number as well as the clock drift rate. With this model, the accumulated synchronization errors of sampling events are estimated. Then, the number of clock ticks in each sampling interval is adjusted dynamically to eliminate the accumulated errors timely. A series of simulations and experiments are performed and the effectiveness of the proposed compensation method is validated. The theory analysis and simulation results demonstrate that the compensation method can keep the accumulated synchronization errors below half of a clock tick interval. In the experiments, with 18 MHz sampling clocks, the average synchronization errors of sampling events during a 200ms resynchronization period are below 160 ns, which is much smaller than 1580 ns for uncompensated clocks. In addition, the non-linear distortions in the sampled signals caused by clock updates are also alleviated by the compensation method.

Joint Adaptive Clock Recovery Mechanism for SAToIP and Performance Analysis

The Study and Analysis of Joint Adaptive Clock Recovery Mechanism for Tdmoip

Instant Recovery--a New Recovery Algorithm for TCP Congestion Control

ATCS: an Adaptive TCP Coding Scheme for Satellite IP Networks

Clock Recovery and Audio/Video Synchronization in Digital TV System

Design and Implementation of Clock Recovery Algorithm in TDM-over-IP

A statistical jitter tolerance estimation applied for clock and data recovery using oversampling

Improvement method to the timing recovery for ATM circuit emulation

Super Wide-Range Variable-Rate Timing Recovery Scheme and Implementation

Clock Recovery for Cbr Traffic in Wireless Atm Networks

A symbol-rate timing recovery method for low-energy high-speed wireless communication system

Fast and accurate clock recovery in packet switched networks

Improved Timing Recovery for Burst OFDM Signal Receive

Resilient Clock Synchronization Architecture for Industrial Time-Sensitive Networking

A Clock Drift Compensation Method for Synchronous Sampling in Sensor Networks

A Novel Approach for Symbol-Rate Timing Recovery Based on Adaptive Interpolation

Research on timing recovery in wireless ATM networks

A Rough Timing Recovery Method for OFDM Systems

An Improved Clock Cycle Measurement Method for High-Speed Serial Signal with Duty-Cycle-Distortion Jitter

Optimization Of Symbol Timing Recovery For Dtmb Receivers

A research on adaptive PCM clock recovering