Abstract:With the rapid development of information technology, high-speed digital optical signal transmission technology has become the core of modern communication networks. However, the increase in transmission rates brings challenges such as noise, distortion, and interference, which affect the accuracy of clock recovery. To address these issues, this study proposes a clock recovery algorithm based on the eye diagram opening area to improve the accuracy and efficiency of high-speed digital optical signal jitter measurement. The proposed method extracts clock information from the signal using the opening area and curvature characteristics of the eye diagram for jitter measurement. Experimental results demonstrate that the clock recovery algorithm based on the eye diagram opening area can stably reconstruct the signal eye diagram and obtain jitter parameters under different optical power conditions. At optical powers of -7.2 dBm, -12.2 dBm, and -17.2 dBm, the Q-factors were 8.8, 7.6, and 4.3, respectively, and the RMS jitter values were 12.2 ps, 13.4 ps, and 21.2 ps, respectively. At optical powers of -2.3 dBm, 0.1 dBm, 2.4 dBm, 4.6 dBm, and 6.0 dBm, the Q-factors were 9.1, 9.3, 9.5, 9.7, and 10.0, respectively, and the average jitter values were 8.9 ps, 8.5 ps, 8.0 ps, 7.5 ps, and 7.0 ps. These results indicate that the proposed algorithm performs excellently under low optical power conditions and maintains high recovery accuracy even when jitter increases at higher optical powers. The clock recovery algorithm based on the eye diagram opening area significantly improves the accuracy and stability of high-speed digital optical signal jitter measurement, enriches the theoretical research of clock recovery algorithms, and shows significant advantages in improving signal transmission quality, reducing bit error rate, and enhancing communication link reliability. The research outcomes provide key technical support for the optimization of modern high-speed optical communication systems.

Fast and accurate clock recovery in packet switched networks

Instant Recovery--a New Recovery Algorithm for TCP Congestion Control

A Study and Analysis of High-Accuracy Network Synchronization Based on IEEE1588

Clock Recovery and Audio/Video Synchronization in Digital TV System

Clock Synchronization Method in Wireless Sensor Networks Based on Local Clock Self-Correction

A New Device Clock Error Based Data Synchronization Method for Current Differential Protection of Transmission Lines

Clock Recovery for Cbr Traffic in Wireless Atm Networks

Design and Implementation of Clock Recovery Algorithm in TDM-over-IP

Adaptive Clock Recovery for CBR Traffic under Static-Priority Scheduling

Optimization of Delay in Network Time Synchronization Algorithm

An enhanced time synchronization method for a network based on Kalman filtering

Hardware-based Solution of Precise Time Synchronization for Networked Control System

A New Architecture High Speed Clock and Data Recovery Circuit

Research on high-speed digital optical signal jitter measurement technology based on clock recovery algorithm using eye diagram opening area

Synchronization of Stochastic Complex Dynamical Networks Subject to Consecutive Packet Dropouts

Evaluation of a Subnanosecond Clock and Data Recovery Technique Via Matlab Simulink and Opti-System Co-Simulation

Design and Implementation of a Rapid Synchronous Clock and Data Recovery Circuit

A Novel Clock and Data Recovery Scheme for 10gbps Source Synchronous Receiver in 65nm CMOS.

Consensus-based Clock Synchronization for Wide Area Networks

Improvement method to the timing recovery for ATM circuit emulation

WR-enhanced TDM-PON with nanosecond clock and data recovery and picosecond time synchronization