Abstract:High-temperature superconductor (HTS) coated conductors (CC) are often wound into pancake coils with electrical insulation in-between the turns. The copper terminals are used for current injection and conduction cooling. An inherent variation of the critical current along the CC length results from its manufacturing process. This variation causes non-uniform heat generation, particularly when the coil is operated at a high fraction of the nominal critical current or when large critical current defects are present. The temperature distribution resulting from the balance between cooling and heating, in combination with the magnetic field and critical current distributions, determines whether a thermal runaway occurs. Accurately predicting the level of critical current defects that can be tolerated during conduction-cooled operation is difficult and requires a 3D coupled electromagnetic and thermal simulation. This paper presents the results of simulations that are performed with the open-source Finite Element Quench Simulator (FiQuS) tool developed at CERN as part of the STEAM framework. The 3D coupled magnetodynamic-thermal simulations are based on the H-phi formulation and use thin shell approximations, a CC homogenization and conduction-cooling. The critical current (Ic) is varied along the CC length. The effect of a single defect specified as a reduction of Ic along the CC length is investigated in terms of the coil's ability to reach and maintain the operating conditions. The Ic and length of the defect that results in a thermal runaway are analyzed in terms of defect location. In addition, a classical 1D scenario with a quench heater is studied. Both the local defect and the heater cases are compared in terms of the voltage signal available for quench detection. These cases result in very different requirements for quench detection, and their implications are discussed.

Numerical Analysis of Stability Margin and Quench Behavior of Cable-in-conduit NbTi Conductors for KSTAR

Moving Mesh Application for Thermal-Hydraulic Analysis in Cable-in-conduit-conductors of KSTAR Superconducting Magnet

Thermohydraulic Behaviors of Kstar Pf Superconducting Magnet System in Operation

Numerical Investigation of Quench Event in the Innermost Pair of the KSTAR Central Solenoids

Thermohydraulic Characteristics of KSTAR Magnet System Using ITER-like Superconductors

Operating Temperature Margin and Heat Load in PF Superconducting Coils of KSTAR

Stability Analysis of the Kstar Pf Busline

Analysis of the Structural Behavior of the KSTAR TF Magnet for Safe Operation

Performance of the Quench Detection System for the KSTAR CS Magnet System

Design Updates and Thermo-Hydraulic Analysis of K-DEMO CS Magnets

Hydraulics of KSTAR Central Solenoid Model Coil 2nd Campaign

Design Study on a 100-Ka/20-k HTS Cable for Fusion Magnets

Qualification Test Results of the KSTAR Superconducting Coils from the Construction to the Commissioning Steps

Development of an Inductive Noise Cancellation Method for Quench Detection of the KSTAR CS Coils by Introducing Improved Plasma Modeling

Influence of Critical Current Distribution on Operation, Quench Detection and Protection of HTS Pancake Coils

Analysis of Voltage Noises for the Reliability Improvement of the KSTAR CS Quench Detection

Dynamic Simulation on Flow Characteristics of KSTAR PF Magnet Cryogenic Network

Energetic Passing Particle-Driven Instabilities and Their Impact on Discharge Evolution in KSTAR

Experimental Evaluation of a Mutually Induced Voltage Correction Method to Improve the KSTAR Quench Detection System

Operational Results of a Thermal-Hydraulic Quench Detection System for the KSTAR TF Superconducting Coils

Numerical Study on Thermal Stability of No-Insulation Coils Using a Three-Dimensional Finite-Element Model