Abstract:High-temperature superconductor (HTS) coated conductors (CC) are often wound into pancake coils with electrical insulation in-between the turns. The copper terminals are used for current injection and conduction cooling. An inherent variation of the critical current along the CC length results from its manufacturing process. This variation causes non-uniform heat generation, particularly when the coil is operated at a high fraction of the nominal critical current or when large critical current defects are present. The temperature distribution resulting from the balance between cooling and heating, in combination with the magnetic field and critical current distributions, determines whether a thermal runaway occurs. Accurately predicting the level of critical current defects that can be tolerated during conduction-cooled operation is difficult and requires a 3D coupled electromagnetic and thermal simulation. This paper presents the results of simulations that are performed with the open-source Finite Element Quench Simulator (FiQuS) tool developed at CERN as part of the STEAM framework. The 3D coupled magnetodynamic-thermal simulations are based on the H-phi formulation and use thin shell approximations, a CC homogenization and conduction-cooling. The critical current (Ic) is varied along the CC length. The effect of a single defect specified as a reduction of Ic along the CC length is investigated in terms of the coil's ability to reach and maintain the operating conditions. The Ic and length of the defect that results in a thermal runaway are analyzed in terms of defect location. In addition, a classical 1D scenario with a quench heater is studied. Both the local defect and the heater cases are compared in terms of the voltage signal available for quench detection. These cases result in very different requirements for quench detection, and their implications are discussed.

Moving Mesh Application for Thermal-Hydraulic Analysis in Cable-in-conduit-conductors of KSTAR Superconducting Magnet

Simulation on Helium Expansion and Quench in Cicc for Kstar with Moving Mesh Methods

Real‐time Calculation of Three Core Cable Conductor Temperature Based on Thermal Circuit Model with Thermal Resistance Correction

Modeling of the Stacked High-Temperature Superconducting Cable-in-Conduit Conductor for High-Field Magnet Applications

Numerical Investigation on Transverse Heat Transfer Properties in Cross Section of Full Size Nb3Sn CICC ITER Conductor

Structural Design and Mechanical Analysis of HTS CICC Made From Twisted Stack Slotted-Core Cable

Operating Temperature Margin and Heat Load in PF Superconducting Coils of KSTAR

Holistic numerical simulation of a quenching process on a real-size multifilamentary superconducting coil

Hydraulics of KSTAR Central Solenoid Model Coil 2nd Campaign

Influence of Critical Current Distribution on Operation, Quench Detection and Protection of HTS Pancake Coils

Thermohydraulic Behaviors of Kstar Pf Superconducting Magnet System in Operation

Thermohydraulic Characteristics of KSTAR Magnet System Using ITER-like Superconductors

Magneto-Thermal Thin Shell Approximation for 3D Finite Element Analysis of No-Insulation Coils

Thermal analysis on helium gas cooled MgB2 DC superconducting cable

Design Study on a 100-Ka/20-k HTS Cable for Fusion Magnets

Thermal-Fluid Analysis of Coaxial Bipolar Superconducting DC Energy Pipeline

Dynamic Simulation on Flow Characteristics of KSTAR PF Magnet Cryogenic Network

Thermal Circuit Modeling and Numerical Verification for Concurrent Fluid Flows through an Iso-Flux Heated Concentric Double Tube

J model for studying AC magnetization loss in 3D cable structures

Multiscale modelling on the multi-physical behaviors of high temperature superconducting magnets based on a combined global homogenization and local refinement scheme

Cfd -Based Modelling On Inter Facial Heat Transfer For Water Quenching