Abstract:Quality of long products surface is an important consumer property of it. In the process of measures elaboration aimed at the increase of long products surface quality, in particular of bars produced at the mill 370/150 of ОJSC “BMZ – managing company of holding “BMK”, studies were accomplished by metallographic laboratory. It was established that defects being revealed at the bars finishing, don’t relate to the quality of continuously casted billet (CCB), but formed in the process of deformation. Studies of the mechanism of surface defects formation on hot-rolled bar of rolling origin – deformation fissure and wrinkles were carried out. Results of numerical simulation of rolling in roughing group of stands at various temperature-deformation parameters presented. Regularities of formation of surface defects on the bar in the finished product were revealed. It was shown that the reason of the surface defects of rolling origin – deformation fissure and wrinkles was a high temperature gradient between the core and the surface of billet, originated from local overheating of surface in the angles zone of CCB resulted in nonuniformity of drawing out of different layers of the billet being deformed. To eliminate the defects, minimum possible temperature gradient between the surface and the core of a billet by controlled rolls cooling should be provided. By calculation, the maximum permissible temperature of the working surface of the rolls of the rough group of stands was established, and empirically the actual temperatures of the rolls with the current production technology, as well as the temperature of the rolls support bearings seats of the rolls were measured. The technical and technological possibilities for improving of rolling technology on a bar and wire mill in order to improve the surface quality of rolled bars were demonstrated. The existing technology was adjusted and new technological modes of rolling with controlled cooling of the rolls were established, which made it possible to significantly reduce the rejection of the finished product due to defects in rolling production. A device was proposed for the roughing group of stands, which enables to minimize the ingress of coolant onto the bar rolled.

Practice of Controlled Rolling Process for Ribbed Bar

Production Practice of Rolling 8mm Thickness Plate by 4300mm Heavy Plate Mill

Research and development practice of HRB400 hot rolled ribbed steel bar

Mechanism of Improved Ductility of 1500 MPa-class Ultra-high Strength Cold-rolled Steel Sheet Produced by Rolling and Partitioning Method

Mechanism of Improved Ductility of 1,500 MPa-class Ultra-high Strength Cold-rolled Steel Sheet Produced by Rolling and Partitioning Method

Effects of Controlled Rolling and Controlled Cooling on the Mechanical Properties of 550mpa Grade Engineering Mechanism Steel

Industrial Trial of Dual Phase Steel in Continuous Casting and Continuous Rolling with Low Coiling Temperature

Effect of Controlled Rolling on the Strength and Toughness of Low‐Alloy Martensitic Steel

Production Process Research and Quality Analysis of 77B Wire Rod

Effects of controlled cooling temperature on microstructure and peformance of V-Nb microalloyed high-strength rebars

IMPROVEMENT OF FOUR-LINE SPLITTING ROLLING OF Φ12 mm DEFORMED STEEL BAR

A study of conditions of surface defects formation when bar rolling at a bar and wire mill and methods of their elimination

The influence of process parameters on the mechanical properties of hot rolling dual phase heavy steel plate

Experimental study on the surface defects of materials in bar rolling with a processing map applicable to billet-to-oval groove rolling

Optimizing Rolling Process Parameters of 65Mn Steel for Metallurgy Saw Blade by Thermal Simulation

Effect of Heavy Warm Rolling on Microstructures and Mechanical Properties of AISI 4140 Steel

Small Range Control of Pearlite Microstructure and Properties of 65Mn Hot Rolled Narrow Strip

Effects of rolling process on microstructure and mechanical properties of ultra high strength steel

Heterogeneous Fe-Mn-Al-C Lightweight Steel Breaking the Strength-Ductility Trade-off Via High-Temperature Warm Rolling Process

Effect of Controlled Rolling and Cooling on Continuous Cooling Transformation of High Nb Containing Microalloyed Steel

Influence of Rolling Process on Band Structure of J55 Oil Casting Steel Strip