Abstract:Effect of boron on the hot ductility and room-temperature tensile properties of Ti-Nb-microalloyed steels containing 0.071 wt.% carbon was studied. The thermal stress and thermal strain of continuous casting billets during cooling were simulated via hot tensile tests at the deformation rate of (6 mm/11,000)/s, and the hot ductility of different microalloyed steels was evaluated according to the area reduction of hot tensile specimens. It was found that boron addition was beneficial to improve the hot ductility of continuous casting billets during straightening, and the reduction of area exceeded 60%. The addition of boron, as well as the removal of molybdenum and vanadium, can effectively lower the austenite-to-ferrite transformation temperature and restrain the formation of intergranular ferrite, so as to avoid the brittle zone. Moreover, the room-temperature tensile properties of the steels were explored at different cooling rates after the rolling process. The results showed that as the cooling rate increased from 0.0094 to 0.13 °C/s, the amount of carbonitride precipitate gradually decreased, such as titanium carbide, leading to the relatively low tensile strength. On the other hand, the addition of boron, as well as the removal of Mo and V, promoted the formation of bainite and acicular ferrite, playing an important role in structure strengthening, and compensated for the decrease of tensile strength caused by the low precipitation strengthening.

Research and development practice of HRB400 hot rolled ribbed steel bar

Strengthening mechanism of HRB400 rebar bearing chromium or vanadium

The Effect of Direct Rolling of Without-heating process on the Microstructure and Properties of a 400 MPa Rebar

Effect of cooling rate and Nb synergistic strengthening on microstructure and mechanical properties of high-strength rebar

Temperature Influence on Section Uniformity of Casting Steel Rolled with the Hot-Core Heavy Reduction Rolling Process and Traditional Hot Rolling Process

Effect of Nitrogen Content and Cooling Rate on Transformation Characteristics and Mechanical Properties for 600 MPa High Strength Rebar

Study on the Effect of Long Holding Time on Improving the Microstructure and Mechanical Properties of Nb Microalloyed Steels

Quantitative analysis of microstructure and mechanical properties of Nb–V microalloyed high-strength seismic reinforcement with different Nb additions

Development of Air-Cooled Super Strength Finish Rolled Rebar

Technology Development of High Toughness and Ultra-heavy Plate Rolled by 400mm Continuous Casting Billet

Effect of Processing Technology on Mechanical Properties of HRB500 High-Strength Steel Bar Threading

Research on Microstructure and Property of Hot-Rolled 700MPa Grade Automobile Sheet

Effect of Boron on Hot Ductility and Room-Temperature Tensile Properties of Microalloyed Steels with Titanium and Niobium

The Performance of Niobium-Microalloying Ultra-High-Strength Bridge Cable Steel during Hot Rolling

Influence of hot-core heavy reduction rolling on microstructure uniformity of casting billet

Research on Nb-containing hot-rolling TRIP steel

Interface Microstructure and Properties of Vacuum-Hot-Rolled 55#/316L Clad Rebars

Enhanced ductility of strong cold-rolled ribbed rebar through intermediate frequency induction heat treatment based on recrystallization

The Effect of RRA Treatment on Mechanical Properties and Wear Behavior in Vanadium Micro-alloyed Hadfield’s Steel

Central Segregation of High-carbon Steel Billet and Its Heredity to the Hot-rolled Wire Rods

Application of niobium microalloying in heat treatment of engineering steels