Abstract:Lithium lanthanum titanate solid electrolyte has high bulk conductivity and stability at high potentials but suffers from low grain boundary conductivity and instability at low potentials. In order to mitigate these two limitations, the effect of single partial substitutions on perovskite (Li-La-Ti-O) materials was studied. The X-ray diffraction patterns showed that numerous substituents enable pure-phase perovskite, a feat that could not previously be accomplished in the unsubstituted materials. Bond valence mismatch is used as a simple predictor of the substitution site and shows that remarkably high mismatches can be tolerated by the perovskite structure. The best substitutions had minimal impact on bulk conductivity but induced minor enhancements in the grain boundary conductivity. Some elements, such as Cr and Mn, increased the electronic conductivity producing good candidates for the electrolyte in the composite cathode for an all-solid-state battery. The electrochemical stability limits were also shifted either to higher or lower potentials by substitutions. Cr substitution resulted in the electrolyte becoming a cathode material with a highly reversible redox peak near 3.43 V (vs Li/Li+). A thorough screening, therefore, yields a combination of materials (unsubstituted as the anode/electrolyte and Cr-substituted as the cathode) that represents a strong candidate for the elusive epitaxial battery, an ideal application of this class of materials given the very high bulk conductivities. Some substitutions also extended the low potential stability limit to below 1.5 V, a shift that would allow the use of Li4Ti5O12 and Nb-based anodes without a buffer layer. Overall, this work shows to what extent the properties of LLTO perovskites can be tuned with substitution in order to meet various application requirements.

The Study on the Substitution In3+and Nd5+ into Perovskites-Type Compounds Li3xLn0.67-xIny Ti1-2yNbyO3

Structure evolution and electric-field-induced reversible transition in perovskite Na(Nb<sub>1-</sub><i><sub>x</sub></i>Ta<i><sub>x</sub></i>)O<sub>3</sub> ceramics

Study On Lithium Fast Ion Conductors Of Li3xla0.67-Xinyti1-2ypyo3 System

The Study of Lithium Fast Ion Conductors of Li3xLa0.67−xScyTi1−2yNbyO3 System

Preparation of solid solutions [Li3xLa0.67-xYyTi1-2yNbyO3] and its lithium-ion conductivity

Study on Lithium Fast Ion Conductors Ofli_(3x)la_(0.67-X)fe_yti_(1-2y)nb_yo_3 System

Structure and Conductivity of Perovskite Li0.355La0.35Sr0.3Ti0.995M0.005O3 (M = Al, Co and In) Ceramics

Effects of Nano-Sized In2O3on Sintering Behavior and Electrical Properties of 0.28Pb(in1/2nb1/2)o3-0.40Pb(mg1/3< /Sub>nb2/3)o3-0.32Pbtio3ceramics

Structure and Conductivity of Perovskites Sr1−xLaxTi1−xCrxO3

Benefits and Limitations of 226 Substitutions into Li-La-Ti-O Perovskites

Formation and characterization of Li0.24+2xLa0.59-xMx TiO3-LaPO4 (M = K, Na) system

Microstructure and ionic conductivity of Li0.5-La0.5(Ti1-Nb )O3 solid-state electrolytes

Preparation, structure and electrical properties of L7i0.67Sr0.33MnO3(Ln=La, Pr, Nd, Sm)

Effect of Sr and Nb co-doped on the total conductivity of Li0.5La0.5TiO3 ceramic electrolytes

Ionic Conduction, Colossal Permittivity and Dielectric Relaxation Behavior of Solid Electrolyte Li3xLa2/3-xTiO3 Ceramics

Phase transitions in A-site substituted perovskite compounds: The (Ca1–2xNaxLax)TiO3 (0⩽x⩽0.5) solid solution

Lithium Ion Conductivity of the B-site Substitution in Li 3x La 0.67−x RE Y III Ti 1−2y P Y O 3 System (RE III =sc 3+ , Y 3+ , Nd 3+ , Sm 3+ , Eu 3+ , Yb 3+ )

Effect Of Sr2+ On Properties Of Li0.2375+Xla0.5875-Xsrxtio3-Lapo4 System

The effect of Ca 2+ in Li 0.24+x La 0.59−x Ca x TiO 3 -LaPO 4 system

High-Pressure and -Temperature Synthesis and Its XPS Study of La1-xNaxTiO3.

Sites and Mobility of Lithium along the Li 1+ x Ti 2- x In x (PO 4 ) 3 (0 ≤ x ≤ 2) Series Deduced by XRD, NMR, and Impedance Spectroscopy