Abstract:The quality of injection molded polymer products can be compromised due to the occurrence of residual stresses inherent to the molding process. In order to determine the parameters that influence the dimensional changes and residual stresses of injection molded polypropylene; computer simulations, chemical, thermal and mechanical characterizations were performed. Statistically, we evaluated two conditions of part geometry (with and without rib), three holding pressures (25, 60 and 96 MPa) and three post-molding conditions (without restriction, with restriction followed by water, and with restriction followed by annealing). The specimens molded with ribs and lower holding pressures showed greater warpage, which agreed with the computer simulations. The smooth specimens submitted to annealing followed by air cooling showed lower warpage in relation to the other two post-molding conditions. The thermal analysis presented a lower degree of crystallinity in the samples without post-molding restrictions. The samples submitted to the annealing heat treatment showed an increase in impact strength, and there was no significant variation in the modulus of elasticity for the post-molding conditions evaluated. The ribbed specimens exhibited higher residual stresses than the smooth specimens. Samples with greater warpage had lower residual stresses. All samples showed a tensile-compression-tensile behavior along the hole depth. The results showed that the shrinkage values were not influenced by any of the parameters evaluated. However, on the warpage the factor that exerts the greatest influence is the geometry of the part, followed by the holding pressure; and the post-molding condition presented the least influence among the analyzed factors.

Warpage Analysis of a Printer Top Cover in the Plastic Injection Molding Based on Moldflow

Influence of mold design and injection parameters on warpage deformation of thin-walled plastic parts

Warpage analysis and optimization of thin-walled injection molding parts based on numerical simulation and orthogonal experiment

Analysis of Mobile Phone Support Fixed for Injection Molding Process Design Based on Moldflow

Analysis of the Warpage Phenomenon of Micro-Sized Parts with Precision Injection Molding by Experiment, Numerical Simulation, and Grey Theory

Application of CAE for mold flow analysis in plastic molding mold design

Mold modification methods to fix warpage problems for plastic molding products

3D Simulation of Residual Thermal Stress and Shrinkage in Plastic Injection Molding

Application of Moldflow Analysis to Optimizing Design of Parts with Metal Insert

Warpage analysis of a Door Carrier Plate in the injection molding Considering the characteristics of LFT

Design and Parametric Optimization of the Injection Molding Process Using Statistical Analysis and Numerical Simulation

Residual stresses, shrinkage, and warpage of complex injection molded products: Numerical simulation and experimental validation

Influence of process parameters and post-molding condition on shrinkage and warpage of injection-molded plastic parts with complex geometry

Shrinkage and Warpage Mechanism of Overflow Water-Assisted Injection Molding Short Fiber-Reinforced Polymers

Numerical Optimization of Shrinkage and Warpage on the Injection Molding Process Parameters of Electrical Connector

Topological and Parameter Optimization Design on Front Platen of Injection Molding Machine

Experimental Study on Warpage Phenomenon of Wax Parts Manufactured by Fused Filament Fabrication

Local thermal warpage deformation of polypropylene injection molded flat part and neural network prediction model

SHRINK AND DEFECT ANALYSIS OF HDPE THICK PART

Cavity Filling Analysis of Injection Molding Simulation:The Formation of Bubble and Weld Line

Injection over-molding warpage prediction of continuous fiber-reinforced thermoplastic composites considering yarn reorientation