Abstract:Micro-electro-mechanic-system (MEMS) devices on flexible substrate are important for non-planar and non-rigid surface applications. In this paper, a novel and cost-effective fabrication process for an 8×8 MEMS temperature sensor array with a lateral dimension of 2.5mm×5.5mm on a polyimide flexible substrate is developed. A 40μm thick polyimide substrate is formed on a rigid silicon wafer using as a mechanical carrier throughout the fabrication by four successive spin coating liquid polyimide. The arrayed temperature sensing elements made of 1200Å sputtered platinum thin film on polyimide substrate show excellent linearity with a temperature coefficient of resistance of 0.0028/°C. The purposed sensor obtains a high sensitivity of 0.781Ω/°C at 8mA at constant drive current. Because of the low heat capacity and excellent thermal isolation, the temperature sensing element shows excellent high sensitivity and a fast thermal response. The finished devices are flexible enough to be folded and twisted achieving any desired shape and form. Employing spin-coated liquid polyimide substrate instead of solid polyimide sheet minimizes the thermal cycling as well as improves the production yield. This fabrication technique first introduces the spin-coated PDMS (Polydimethylsiloxane) interlayer between the silicon carrier and the polyimide substrate and makes the polyimide-based devices separate much easier and greatly simplifies the fabrication process with a high production yield. A non-successive two-stage cure procedure for the polyimide precursor is developed to meet low-temperature requirement of the PDMS interlayer. The fabrication procedure developed in this research is compatible with conventional MEMS technology through an optimized integration process. The novel flexible MEMS technology can benefit the development of other new flexible polyimide-based devices.

Elastic MEMS Probe Card Based on the PDMS Substrate

The Design and Fabrication of 3D Micro Spring Type MEMS Probe Card

MXene@CTAB@CMF Three-Dimensional Elastic Base for Piezoresistive Pressure Sensors Realized by Electrostatic Self-Assembly

Design and Fabrication of A Micromachined Bilayer Cantilever Probe Card

Two-Dimensional Dense-Arrayed Probe-Cards with A Hoe-Shaped Probing-Tip Micromachining Technique

Experimental and Theoretical Study on Mechanical Properties of Porous PDMS

High performance MEMS tactile sensor array with robustness and fabrication simplicity

Highly elastic conductive polymeric MEMS

RF Pogo-Pin Probe Card Design Aimed at Automated Millimeter-Wave Multi-Port Integrated-Circuit Testing

An Integrated MEMS Tactile Tri-Axial Micro-Force Probe Sensor for Minimally Invasive Surgery

Design and Performance Test of MEMS Tri-Axial Micro-Force Probe Sensor

A Facile Strategy for Low Young's Modulus PDMS Microbeads Enhanced Flexible Capacitive Pressure Sensors

MEMS-on-fiber sensor combining silicon diaphragm and supporting beams for on-line partial discharges monitoring

Research on PDMS-based multi-layer interconnection system for chip and electrodes

Design and fabrication of a novel silicon probe for micromachined surface profilers

Fabrication and testing of a novel silicon probe for micromachined surface profilers.

Fabrication and Characterization of Probes for Combined SPM Techniques Based on PECVD

Boosting Sensitivity and Durability of Pressure Sensors Based on Compressible Cu Sponges by Strengthening Adhesion of "Rigid‐Soft" Interfaces

PDMS Prism-Glass Optical Coupling for Surface Plasmon Resonance Sensors Based on MEMS Technology

Shielded Piezoresistive Cantilever Probes for Nanoscale Topography and Electrical Imaging

A Novel Fabrication Process of MEMS Devices on Polyimide Flexible Substrates