Abstract:With the rapid development of flexible electronics, an increasing number of microfabrication strategies originating from the Si-based integrated circuits field have been explored on organic materials. Parylene C, a polymer, has been widely used in the microelectromechanical systems (MEMS) field because of its outstanding fabrication merits, such as room-temperature processability, conformal coating, and precise thin film deposition capability with the thickness tunable from 1 nm to 100 μm. As a good dielectric material, the Parylene C is also suitable for interlayer dielectrics (ILD) in flexible electronics. This study develops an optimized chemical mechanical polishing (CMP) technique of Parylene C for high-density redistribution wiring in high-performance flexible electronics. The roughness of the Parylene C surface after CMP was as low as 14.3±1.5 Å. The problems of slurry pollution and mechanical failure of the Parylene film that degrade the dielectric performance of the Parylene C could be avoided by taking the optimized CMP method. The multi-material structure constructed by Parylene C, Silicon and electroplated Copper was prepared and polished using the optimized CMP process. Additionally, a flexible wiring sample has been successfully patterned by the Damascene process through the optimized CMP process. In this sample, both the distance between each wire and the wire width were as small as 5 μm.The optimized Parylene C CMP process is easy-to-realize, highly efficient, low cost, and with minor defects; it provides a promising way to achieve high-density interconnection in high-performance flexible electronic devices.

Research on PDMS-based multi-layer interconnection system for chip and electrodes

The Research on Integrated Cellular Chip Based on Multifunction Cell-based Biosensor

A simple method for fabricating multi-layer PDMS structures for 3D microfluidic chips

Reasearch and fabrication of integrated pneumatic microvalves in polymer microfluidic chip

Evaluation of different PDMS interconnection solutions for silicon, Pyrex and COC microfluidic chips

Rapid Customization of 3d Integrated Microfluidic Chips Via Modular Structure-Based Design

Microfluidic Device with Compound Structure

Fabrication of the PDMS-Glass Microfluidic Chip with Integrated Electrodes

Wafer-Level 3D Integration Based on Poly (Diallyl Phthalate) Adhesive Bonding

Optimized chemical mechanical polishing of Parylene C for high-density wiring in flexible electronics

Design and fabrication of MEMS devices using the integration of MUMPs, trench-refilled molding, DRIE and bulk silicon etching processes

Efficient Bond of PDMS and Printed Circuit Board with An Application on Continuous-flow Polymerase Chain Reaction

Fabrication of PDMS micro through-holes using micromolding in open capillaries

High performance MEMS tactile sensor array with robustness and fabrication simplicity

Elastic MEMS Probe Card Based on the PDMS Substrate

Route to one-step microstructure mold fabrication for PDMS microfluidic chip

Observation Interface of PDMS Membrane in a Microfluidic Chip Based on One-Step Molding

Study On Electrical Performance Of Stacking Die Package With Silicon Interposer

Fabrication of Poly(dimethylsiloxane)-Based Capillary Electrophoresis Microchips Using Epoxy Templates

Removable Fast Package Technology For Mems Devices Using Polymer Connectors And Silicon Sockets

Parylene-MEMS Technique-Based Flexible Electronics