Abstract:A high reliability is essential for the insulation system of wind turbine generator because of its high repairing cost. In this paper, three experimental methods based on accelerated aging under repetitive impulse voltage and multi-environmental factors are established to (i) investigate the failure or degradation mechanism during the aging, and (ii) make recommendations on how to assess the functional life and reliability of insulation systems for wind turbine generator. Repetitive impulse voltage stress combined with thermal stress, change of temperature, steady damp heat and salt mist was, in turn, applied to model specimens with different length and section sizes. Some of non-destructive characteristic parameters such as dissipation factor, insulation resistance, and partial discharge inception voltage were measured periodically during the aging. In addition to the residual breakdown voltage, the appearance features and infrared spectrum analysis of specimens were carried out after aging. It has been found that the surface partial discharge generated under repetitive impulse voltage resulted in the degradation of surface insulating material near the slot end. The change of temperature also caused the delaminating of stator insulation from the core slot especially when massimpregnated insulation used in long slot of practical stator. The increase of dissipation factor of insulation system was largely contributed by salt mist and moisture factors especially when the surface or interface of insulation material was damaged. The electrically accelerated aging under about triple maximum repetitive impulse voltage for 1000 h was an effective and feasible method to assess the insulation system of wind turbine generator.

Dielectric Loss Study of Inverter-fed Traction Motor Twisted Pair

Research on Deterioration Mechanism of Oil-paper Insulation of 220 Kv Current Transformer

Insulation Failure of Inter-Turn Insulation in Inverter-Fed Traction Motor

Electrical tree formation as a measure of degradation resistance in polymeric materials for HVDC applications

Research on AC and High Frequency Breakdown Characteristics of Oil-paper Insulation of 220 Kv Current Transformers

Microscopic View of Aging Mechanism of Polyimide Film under Pulse Voltage in Presence of Partial Discharge

Lifetime Model for Inverter-fed Electrical Machines Windings Including Thermal Aging and Partial Discharge Risk

The Investigation of Electrical Properties for Mica/Epoxy Insulation Stator Bars During the Thermal Cycle Aging Test

Evaluation of Oil Paper Insulation State of Traction Transformer

Traction Inverter Highly Accelerated Life Testing With High-Temperature Stress

Effect of thermal ageing on charge dynamics and material properties of 320 kV HVDC XLPE

Voltage Distribution Analysis of High Dv/dt Fed Machines Using High Frequency Winding Model

On the Frequency Dependence of the PDIV in Twisted Pair Magnet Wire Analogy in Humid Air

Aging Analysis of Transformer Insulation at Weakest Region: Dielectric Parameters Extraction via Immune Optimization

Research on characteristic parameters for multi-factor aging of stator bar insulation of pumped storage generator

Evaluation of the Degradation of Generator Stator Ground Wall Insulation under Multistresses Aging

Simulation on Variation of Electrical Insulation Parameters in Predictive Test Caused by Insulation Aging of Power Transformer

Study of Tracking Wheel Test Method under DC Voltage

Effects of a DC Offset on Lifetime and PD Activity during AC Aging Tests on Enameled Twisted Pairs

Dielectric loss and partial discharge test analysis of 10 kV XLPE cable

Effects of accelerated repetitive impulse voltage aging on performance of model stator insulation of wind turbine generator