Plastic Limit Load Analysis of Tee Joint Containing Corner Cracks
Lijie Chen,Yinghua Liu,Tieqiang Gang
DOI: https://doi.org/10.1063/1.3452188
2010-01-01
AIP Conference Proceedings
Abstract:In this paper, we first introduce the iterative method of the modified elastic compensation method (KtECM) proposed by the authors, which can be used for limit load analysis of complex structures. Then, plastic limit load of thin-walled tee joint containing corner cracks under internal pressure is computed by using the KtECM, the elastic compensation method (ECM), and the elastic-plastic analysis method (EPAM). During computations, we consider three different possible crack propagation modes including the crack growing along the run pipe, the crack growing along the branch pipe, the crack growing in the direction of through the weld zone. These computation results show that the KtECM can provide good estimations of plastic limit loads for cracked structures. The error between the K,ECM solution and the elastic-plastic solution for most computations is within 10%. For tee joint, the crack growing along the run pipe is more dangerous than the crack growing along the branch pipe and when the crack extends to above 68 percent of the welding corner height, the crack growing in the direction of through the weld zone is the most dangerous mode. Finally, we establish the relationship between the crack length and the plastic limit load for the tee joint in this paper by quadratic polynomial and piecewise polynomial function.