Abstract:Longitudinal crack defects are a frequent occurrence on the surface of thin slabs during the high-speed continuous casting process. Therefore, this study undertakes a detailed analysis of the solidification characteristics of hyper-peritectic steel thin slabs. By establishing a three-dimensional heat transfer numerical model of the thin slab, the formation mechanism of longitudinal cracks caused by uneven growth of the initial shell is determined. Based on the mechanism of longitudinal crack formation, by adjusting the performance parameters of the mold flux, the contradiction between the heat transfer control and lubrication improvement of the mold flux is fully coordinated, further reducing the incidence of longitudinal cracks on the surface of the casting thin slab. The results show that, using the optimized mold flux, the basicity increases from 1.60 to 1.68, the F- mass fraction increases from 10.67% to 11.22%, the Na2O mass fraction increases from 4.35% to 5.28%, the Li2O mass fraction increases from 0.68% to 0.75%, and the carbon mass fraction reduces from 10.86% to 10.47%. The crystallization performance and rheological properties of the mold flux significantly improve, reducing the heat transfer performance while ensuring the lubrication ability of the molten slag. After optimizing the mold flux, a surface detection system was used to statistically analyze the longitudinal cracks on the surface of the casting thin slab. The proportion of longitudinal cracks (crack length/steel coil length, where each coil produced is about 32 m long) on the surface of the thin slab decreases from 0.056% to 0.031%, and the surface quality of the thin slab significantly improves.

Numerical Simulation of Stress Field in a Wide Slab Mould of Peritectic Steel Continuous Casting

Simulation Analysis of Thermal Stress During Casting Process of Large-Sized Alloy Steel Ingot

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Numerical simulation analysis of thermal stress fields during solidification of steel casting

Analysis of heat transfer and thermal stress in continuous casting with mechanical reduction

Numerical Simulation of the Thermo-Mechanical Process for Beam Blank Continuous Casting

Analysis of Longitudinal Cracking and Mold Flux Optimization in High-Speed Continuous Casting of Hyper-Peritectic Steel Thin Slabs

Numerical Simulation of Fluid Flow and Solidification in Continuous Slab Casting Mould Based on Inverse Heat Transfer Calculation

A Study on the Numerical Simulation of Thermal Stress During the Solidification of Shaped Castings

Thermo-mechanical Modeling in Continuous Slab Casting Mould and Its Application

Numerical Simulation and Experiments Research on Secondary Cooling Process of Thick Slab Continuous Casting

Numerical Modelling of Chamfer Billet of High Carbon Steel During Continuous Casting

Method for Determining the Boundary Condition of Heat Transfer in Mold for Slab Casting

A coupled model on fluid flow, heat transfer and solidification in continuous casting mold

Thermal stress simulation considering mechanical interaction between casting and mold

Numerical Simulation of Mold Slag Entrapment Behavior in Nonoriented Silicon Steel Production Process

Numerical simulation of shrinkage porosity defect in billet continuous casting

Chamfer and Taper Researches of Mould in Slab Continuous Casting

Heat transfer and solidification microstructure evolution of continuously cast steel by non-steady physical simulation

Numerical Simulation of Stress of Adjustment Sheet During Investment Casting Process

A 2.5D finite element model for bending and straightening in continuous casting of steel slabs