Abstract:The traditional operation mode of high-field Asymmetric Waveform Ion Mobility Spectrometry (FAIMS) uses a one-way radio frequency (RF) voltage input as the dispersion voltage. This requires a high voltage input and limits power consumption reduction and miniaturization of instruments. With higher dispersion voltages or larger compensation voltages, there also exist problems such as low signal intensity or the fact that the dispersion voltage is no longer much larger than the compensation voltage. In this paper, a differential-RF-driven operation mode of FAIMS is proposed. The two-way RF is used to generate the dispersion field, and a phase difference is added between the two RFs to generate a single step waveform field. Theoretical analysis, and experimental results from an ethanol sample, showed that the peak positions of the ion spectra changed linearly (R2 = 0.9992) with the phase difference of the two RFs in the differential-RF-driven mode and that the peak intensity of the ion spectrum could be enhanced by more than eight times for ethanol ions. In this way, it is possible to convert the ion spectrum peaks outside the separation or compensation voltage range into a detectable range, by changing the phase difference. To produce the same separation electric field, the high-voltage direct current input voltage can be maximally reduced to half of that in the traditional operation mode. Without changing the drift region size or drift condition, the differential-RF-driven operation mode can reduce power consumption, increase signal-to-noise ratio, extend the application range of the dispersion voltage and compensation voltage, and improve FAIMS detection performance.

Design of a Rectangular Asymmetric Waveform RF Power Supply for FAIMS

Design of RF Power Supply Control System Based on TMS320F2812 for FAIMS Instrument

Design of High-field Asymmetric Waveform Power Supply for FAIMS

Design of High-Field Asysmmetric Pulse Power Supply for FAIMS

An Object-Oriented Designed Finite-Difference Time-Domain Simulator for Electromagnetic Analysis and Design in MRI

Design of rf front end for cavity beam position monitor based on ics *

Lumped-Network FDTD Method for Simulating Transient Responses of RF Amplifiers Excited by Intentional Electromagnetic Interference Signals

Prototype design of a digital Low-Level RF system for S3FEL S-band Transverse Deflecting Cavities

Performance Enhancement of High-Field Asymmetric Waveform Ion Mobility Spectrometry by Applying Differential-Rf-Driven Operation Mode

Study on Simulation and Experiment of Array Micro Faraday Cup Ion Detector for FAIMS

Experimental and simulation research on the influence of voltage amplitude, frequency and carrier gas flow rate on the performance of FAIMS

An Intelligent Detection Method for High-Field Asymmetric Waveform Ion Mobility Spectrometry

A Research Experiment of the High-Field Asymmetric Waveform Ion Mobility Spectrometry Technology

A DAQ Prototype for Front-end Waveform Digitization in Intensive Electromagnetic Field Circumstance

Design of Signal Acquisition and Processing System Based on TMS320F2812 and LabVIEW for FAIMS

RF Simulation and Improvements of an Ion Source Test Facility at HUST

Effect of Rectangular Radio-Frequency Voltage Amplitude on Performance of A Miniature High-Field Asymmetric Waveform Ion Mobility Spectrometric Sensor Chip

Design and Fabrication of Miniature FAIMS Biochemical Sensor

Experimental Analysis of A New Retarding Field Energy Analyzer

Design and Fabrication of a Miniature FAIMS Sensor Chip

THE STUDY OF SEPARATED FUNCTION RFQ (SFRFQ) WITH DIAPHRAGMS