Abstract:A rapid and reliable quench detection is vital for high current superconducting magnet system to prevent irreversible damage to a magnet by the quench phenomenon. The method for detecting the occurrence of a resistive transition has been widely adopted in the superconducting magnet. In the case of the voltage monitoring by means of dedicated taps, the electron quench detection device (EQDD) conversion unit, which converts detected high voltages into voltage-drop signal, should be required in the superconducting high field magnet. The power source of traditional quench detecting system, which can monitor for superconducting magnet with middle power operation, is supplied through the power transformer since the transformer can provide galvanic isolation between circuits. On the other hand, in the case of the super high magnet systems such as Korea Superconducting Tokamak Advanced Research and International Thermonuclear experimental reactor, since the maximum operation current and voltage of the super high field magnet keep over 60 kA and 50 kV DC, a passive component, which has strong an isolation device and high dielectric resistor qualities, has been required in the super high field magnet. If the power transformer is adopted in the super high field magnet, it can cause high cost for volume capacity since it needs for higher dielectric resistance value over 500 MΩ. Authors proposed the wireless resonance antenna and multi-receiver coils which can keep high level of dielectric resistance value with stability. As well as, the wireless power charging unit can reduce system volume due to multi-charging receivers for one antenna. In this study, authors investigated the effect of inserted resonator (Sx) coil between antenna and receiver coils, as well as, evaluated the electric field and magnetic field among the resonance coils under 300 W 370 kHz RF power generator since the strong electro-magnetic fields by the resonance coils can affect the electron devices inside of the EQDD module.

A DAQ Prototype for Front-end Waveform Digitization in Intensive Electromagnetic Field Circumstance

A Broadband NMR Magnetometer System with Field Searching and Automatic Tuning Function

Low Field NMR System Based on High T_c DC-SQUID

An Integrated Testbed with Single DC Source for Delivering Symmetrical Square-Wave Excitation Voltage in the Triple Pulse Test.

Development of short prototype of dual aperture quadrupole magnet for CEPC ring

Design of a Rectangular Asymmetric Waveform RF Power Supply for FAIMS

Design of High-field Asymmetric Waveform Power Supply for FAIMS

A prototype vector magnetic field monitoring system for a neutron electric dipole moment experiment

An Integrated Dual-Mode Pulse-Echo Ultrasonic Measurement System Under Pulsed/Static Magnetic Field

Ultrafast High-Energy Electron Radiography Application in Magnetic Field Delicate Structure Measurement

Design of transient front-end signal digitizer for x-ray detector in laser inertial confinement fusion facility

Pulsed wire magnetic-field measurement system on permanent magnet quadrupoles

Magnetic coil design of steady magnetic field test facility for Tokamak complex

Development of a High Sampling Rate Data Acquisition System Working in a High Pulse Count Rate Region for Radiation Diagnostics in Nuclear Fusion Plasma Research

Prototype design of a digital Low-Level RF system for S3FEL S-band Transverse Deflecting Cavities

Design and experiment of broadband electric field sensor for high-power sub-nanosecond pulse measurements

A Compact High Voltage Pulse Generator for Bounded-wave EMP Simulator

Design of High-Field Asysmmetric Pulse Power Supply for FAIMS

Practical Investigations of Wireless Multiple-Power Charging Unit for Electron Quench Detection Device in the Super High Field Superconducting Magnet

Progress of Quench Detection for CFETR TF Prototype Coil

Asymmetric Calibration and Characterization for Diff-port Magnetic Field Probing System