Abstract:It was experimentally found that silica and gold particles can modify the combustion properties of nanothermites but the exact role of the thermal properties of these additives on the propagating combustion front relative to other potential contributions remains unknown. Gold and silica particles of different sizes and volume loadings were added into aluminum/copper oxide thermites. Their effects on the flame front dynamics were investigated experimentally using microscopic dynamic imaging techniques and theoretically via a reaction model coupling mass and heat diffusion processes. A detailed theoretical analysis of the local temperature and thermal gradients at the vicinity of these two additives shows that highly conductive inclusions do not accelerate the combustion front while poor conductive inclusions result in the distortion of the flame front (corrugation), and therefore produce high thermal gradients (up to 1010K.m-1) at the inclusion/host material interface. This results in an overall slowing down of the combustion front. These theoretical findings contradict the experimental observations in which a net increase of the flame front velocity was found when Au and SiO2particles are added into the thermite. This leads to the conclusion that the faster burn rate observed experimentally cannot be fully associated with thermal effects only, but rather on chemical (catalytic) and/or mechanical mechanisms: formation of highly-stressed zones around the inclusion promoting the reactant mixing. One additional experiment in which physical SiO2particles were replaced by voids (filled with Ar during experiment) to cancel the potential mechanical effects while preserving the thermal inhomogeneity in the thermite structure confirms the hypothesis that instead of pure thermal conduction, it is the mechanical mechanisms that dominate the propagation velocity in our specific Al/CuO multilayered films.

Effect of Burning Rate on Solidification Microstructure of Thermite Welds

Tailorable Burning Behavior of Ti14 Alloy by Controlling Semi-Solid Forging Temperature

Effect of Arc Surface Remelting on the Corrosion Resistance of 0cr19ni9 TIG Welding Joint

Novel method of thermite welding

Elucidating the dominant mechanisms in burn rate increase of thermite nanolaminates incorporating nanoparticle inclusions

Effect of Welding Defects on Mechanical Properties of Welded Joints Subjected to Temperature

The Efficiency of Thermite-Assisted Underwater Wet Flux-Cored Arc Welding Process: Electrical Dependence, Microstructural Changes, and Mechanical Properties

Study on combustion characteristics and pyrotechnic cutting effects of bimetal thermite Ni/Al/Fe2O3 system

Hazardous effects and microstructure of explosive welding under vacuum environment

Behavior and Mechanism of Void Welding Under Thermal Mechanical Coupling

Influence of Water Cooling Assisted Microplasma Arc Welding of Ti6Al4V Alloy: Correlations with Microstructure

Effect of microstructure heterogeneity on the mechanical properties of friction stir welded reduced activation ferritic/martensitic steel

Microstructure Characteristics after Combustion and Fireproof Mechanism of TiAl-based Alloys

In-Situ Observation On The Influences Of Ti On Phase Transformation Of Weld Metal Processed By High-Heat Input Welding

Numerical Study on Mechanism of Explosive Welding

Study on the mechanism of Ni-26W-6Cr alloy solidification cracking: Effect of laser welding heat input

Microstructure, Corrosion and Mechanical Properties of TiC Particles/Al-5Mg Composite Fillers for Tungsten Arc Welding of 5083 Aluminum Alloy

Preparation and characterization of modified Al/Fe2O3 nano-thermite composite system

Inclusions and Microstructure of Steel Weld Deposits with Nanosize Titanium Oxide Addition

Microstructure evolution and mechanical properties in a gas tungsten arc welded Fe42Mn28Co10Cr15Si5 metastable high entropy alloy

Experimental and Numerical Investigations of the Effect of Charge Density and Scale on the Heat Transfer Behavior of Al/CuO Nano-Thermite