Abstract:In this article, we fabricated ZnO nanorod arrays on ITO substrates by cathodic electrodeposition method under different electrodeposition times. The XRD results illustrate that all of the peaks can be attributed to the hexagonal wurtzite structure. Besides, the crystallinity and the preferred c-axis orientation increase with longer electrodeposition time. With the increasing electrodeposition time, the diameter of nanorods, the surface roughness and thickness of ZnO nanorod arrays also increased. All samples exhibit hydrophobic behavior and the water contact angle (CA) increases to 120 degrees with the electrodeposition time increases to 120 min. After 10 min of ultraviolet (UV) irradiation, the wettability of the ZnO surfaces turn from hydrophobic to hydrophilicity, and the change of the CA reduction rate are 73.5, 63.5, 48.3 and 24.2%, corresponding to the sample electrodeposited 10, 30, 60 and 120 min, respectively. The intensity of UV emission peak ratio increases from 2.26 to 63.84% while the visible emission peak ratio decreases in PL spectra, which reveals defects decrease when electrodeposition time increases from 10 to 120 min. Raman spectrum shows three peaks which are located at 439, 566 and 1097 cm(-1), corresponding to the E-2, E-1L and E-3 mode of ZnO. (C) 2016 The Electrochemical Society. All rights reserved.

Ordered Semiconductor CdO Nanowire Arrays: Synthesising by One-Step Low-Temperature Electrodeposition and Optical Properties

Effect of Electrodeposition Time on Microstructure, Wettability and Optical Properties of ZnO Nanorod Arrays

Conversion of large-scale oriented ZnO rod array into nanotube array under hydrothermal etching condition via one-step synthesis approach

Highly Ordered and Well-Oriented Single-Crystal Cdte Nanowire Arrays by Direct-Current Electrodeposition

One-Step Fabrication of Cds Nanoparticle-Sensitized Tio2 Nanotube Arrays Via Electrodeposition

Synthesis of Highly Ordered CdSe Nanowire Arrays Embedded in Anodic Alumina Membrane by Electrodeposition in Ammonia Alkaline Solution

Diameter- and current-density-dependent growth orientation of hexagonal CdSe nanowire arrays via electrodeposition.

Arrays of ZnO Nanowires Fabricated by a Simple Chemical Solution Route

Large-scale and highly ordered 1D nanostructural arrays by template-assisted electrodeposition

Fabrication of Highly Ordered InSb Nanowire Arrays by Electrodeposition in Porous Anodic Alumina Membranes

Cofe2o4 Nanowire Arrays Prepared by Template-Electrodeposition Method and Further Oxidization

Study on the Structural and Physical Properties of ZnO Nanowire Arrays Grown Via Electrochemical and Hydrothermal Depositions

Preparation of II-VI group semiconductor nanowire arrays by dc electrochemical deposition in porous aluminum oxide templates

Preparation and Characterization of CdS Nanowire Arrays by Dc Electrodeposit in Porous Anodic Aluminum Oxide Templates

Electrochemical Preparation of CdSe Nanowire Arrays

Fabrication and characterization of single-crystalline ZnTe nanowire arrays

Synthesis of Dense, Single-Crystalline CrO2 Nanowire Arrays Using AAO Template-Assisted Chemical Vapor Deposition.

Novel Method Synthesis of Cdo Nanowires

Single Crystalline SnO2 Nanowires Obtained from Heat-Treated SnO2 and C Mixture and Their Electrochemical Properties

Controllable Synthesis of Single-Crystalline CdO and Cd(OH)2Nanowires by a Simple Hydrothermal Approach

Cu Oxide Nanowire Array Grown on Si-based SiO2 Nanoscale Islands Via Nanochannels