Abstract:Two types of amorphous ZrO2 (am-ZrO2) catalysts were prepared by different co-precipitation/reflux digestion methods (with ethylenediamine and ammonia as the precipitant respectively). Then, copper and potassium were introduced for modifying ZrO2 via an impregnation method to enhance the catalytic performance. The obtained catalysts were further characterized by means of Brunauer-Emmett-Teller surface areas (BET), X-ray diffraction (XRD), H2-temperature-programmed reduction (H2-TPR), and In situ diffuse reflectance infrared spectroscopy (in situ DRIFTS). CO hydrogenation experiments were performed in a fixed-bed reactor for isobutanol synthesis. Great differences were observed on the distribution of alcohols over the two types of ZrO2 catalysts, which were promoted with the same content of Cu and K. The selectivity of isobutanol on K-CuZrO2 (ammonia as precipitant, A-KCZ) was three times higher than that on K-CuZrO2 (ethylenediamine as precipitant, E-KCZ). The characterization results indicated that the A-KCZ catalyst supplied more active hydroxyls (isolated hydroxyls) for anchoring and dispersing Cu. More importantly, it was found that bicarbonate species were formed, which were ascribed as important C1 species for isobutanol formation on the A-KCZ catalyst surface. These C1 intermediates had relatively stronger adsorption strength than those adsorbed on the E-KCZ catalyst, indicating that the bicarbonate species on the A-KCZ catalyst had a longer residence time for further carbon chain growth. Therefore, the selectivity of isobutanol was greatly enhanced. These findings would extend the horizontal of direct alcohols synthesis from syngas.

Effect of preparation method on the hydrogen production from methanol steam reforming over binary Cu/ZrO2 catalysts

Influence of the component interaction over Cu/ZrO2 catalysts induced with fractionated precipitation method on the catalytic performance for methanol steam reforming

Hydrogen production via steam reforming of methanol using Cu/ZnO/Al 2 O 3 : Effect of catalyst synthesis method and Cu to Zn molar ratio on physico-chemical properties and catalytic performance

A Highly Efficient Cu/Zno/Al2o3 Catalyst Via Gel-Coprecipitation of Oxalate Precursors for Low-Temperature Steam Reforming of Methanol

Production of hydrogen by steam reforming of methanol over Cu/ZnO catalysts prepared via a practical soft reactive grinding route based on dry oxalate-precursor synthesis

Influences of preparation methods of ZrO2 support and treatment conditions of Cu/ZrO2 catalysts on synthesis of methanol via CO hydrogenation

Hydrogen Production Via Steam Reforming of Methanol on Cu/ZnO/Al2O3 Catalysts: Effects of Al2O3 Precursors

Methanol Steam Reforming for Hydrogen Production over CuZnZrOx: Promotion Effect of Cu

Fe–Ni–Ce–Zr-modified CuO–ZnO catalyst for methanol steam reforming

Hydrolysis Precipitation Method for the Preparation of Cu‐ZnO@Al2O3 Catalyst in Methanol Steam Reforming

Impact of Preparation Methods on the Performance of Cu/Ni/Zr Catalysts for Methanol Decomposition

Effect of Preparation Method on the Performance of Cu‐Mn‐(La)‐Zr Catalysts for CO2 Hydrogenation to Methanol

Highly effective methanol steam reforming Cu/ZnO catalyst prepared by a dry mechanochemical approach based on oxalate precursor synthesis

Hydrogen Production via Methanol Steam Reforming over CuO/ZnO/Al2O3 Catalysts Prepared via Oxalate-Precursor Synthesis

A practical approach for the preparation of high activity Cu/ZnO/ZrO2 catalyst for methanol synthesis from CO2 hydrogenation

PREPARATION OF CuO/ZnO CATALYST FOR METHANOL SYNTHESIS BY CARBON DIOXIDE HYDROGENATION I. Preparation Methods

Methanol Steam Reforming over ZnO/ZnZrOx: Performance Enhanced with a Cooperative Effect

Achieving strong thermal stability in catalytic reforming of methanol over in-situ self-activated nano Cu2O/ZnO catalyst with dual-sites of Cu species

The effect of the preparation on the catalytic activity of ZnO/TiO2 in the methanol steam reforming reaction

Effect of Preparation Method on ZrO2-Based Catalysts Performance for Isobutanol Synthesis from Syngas

Preparation of a Durable CuO/ZnO/CeO2/ZrO2 Catalyst on an SiC Support by an Inverse Microemulsion/Precipitation Method for Methanol Steam Reforming