Abstract:The central deformation extent of the thick plate can be improved and the approaching uniform deformation will be realized by the snake/gradient temperature rolling (SGTR). At present, the existing rolling force analytical models cannot be directly used for SGTR because of the great difference with the synchronous rolling. The rolling force model should be established so as to meet the production demand of the SGTR with different roll diameters. The thick plate is divided into three layers according to the numerical results of the short-term ultra-fast cooling for the thick plate. The deformation region is simplified into different zones and layers according to the temperature gradient and neutral point position. The traditional von Mises yield criterion was optimized by the introduced coefficients c1 and c2 according to the slip line field theory to correct the deviation caused by the uniform and shear stress assumption. The specific pressure equation is established by the slab method. The deformation region with different composition cases is analyzed, and the rolling force and torque analytical models are established according to the boundary conditions on this basis. The short-term ultra-fast cooling and rolling process were simulated by ANSYS software. The deformation resistance gradient produced by short-term ultra-fast cooling and roll diameter ratio are the main factors to affect the rolling force, while the roll offset has little effect on the rolling force because of its small proportion in the deformation region. The position of neutral points not only affects the rolling torque, but also changes its direction in certain conditions. The model precision was analyzed, and the rolling force calculated by the established analytic model is in good agreement with the numerical method, which serves as a theoretical basis for the rolling mill design and process parameter setting.

Study on Rolling Force during Asymmetric Rolling Process

Finite Element Analysis of Temper Rolling Process

A fast calculation method of large-cylinder asymmetrical rolling force considering shear effect

Analytical and Finite Element Analysis of the Rolling Force for the Three-Roller Cylindrical Bending Process

Theoretical Study of Asymmetric Bending Force on Metal Deformation in Cold Rolling

Tri-dimensional Elastic-Plastic Fem of Rolling Force During Strip Finishing Rolling Process

Analysis of Rolling Force Model in Cold Rolling Mill

Rolling Process Analysis of Working Rollers of Cold Rolling Mill Based on ANSYS

The Numerical Simulation of Wheel Rim Roll Forming

Study and improvements on the rolling loads of axial incremental rolling process for spline shaft based on finite element method

Research on the analytical model of rolling force for TiAl alloy pack rolling

STUDY OF ROLLING FORCE MODEL ON HOT STRIP MILL

ASR Bending Force Mathematical Model for the Same Width Strip Rolling Campaigns in Hot Rolling

Theoretical Analysis and Numerical Simulation of External Spline Cold Rolling

Influence of Asymmetric Rolling on the Microstructure, Texture Evolution and Mechanical Properties of Al–Mg–Si Alloy

FEM Analysis and Process Parameter Optimizing of High Speed Wire Rod During Reducing and Sizing Multi-Pass Groove Rolling Process

Analysis of the Asymmetrical Rolling of Ultra-Thin Strips Considering Elastic Deformation of the Strips

Simulation of Roll Forming with Dynamic Explicit Finite Element Method

Calculation and analysis of rolling force during aluminum alloy thick plate snake/gradient temperature rolling with different roll diameters

Finite Element Simulation of Rail Wheel Rolling Process

An Efficient Multi-Scale Modeling Method that Reveals Coupled Effects Between Surface Roughness and Roll-Stack Deformation in Cold Sheet Rolling