Abstract:Low-voltage scanning electron microscopy (LV-SEM) with landing energies below 5 keV has been widely used due to its advantages in mitigating the damage and charging effects to a specimen and enhancing surface information due to small interaction volume of electrons inside a specimen. Additionally, for elemental analysis of the surfaces of bulk specimens with Auger electron spectroscopy (AES) or electron energy loss spectroscopy (EELS), ultra-high-vacuum (UHV) environment is essential to maintain clean surfaces without the absorption of gas molecules during the electron beam irradiation for the acquisition of spectral data. In this study, we propose the optimal design and condition of a conical Electrostatic Objective Lens (EOL) for a UHV LV-SEM to achieve the high spatial resolution and secondary electron (SE) detection efficiency. The EOL is composed of only the three electrodes (retarding, focusing and booster electrodes) and the insulators, which is suitable for maintaining a UHV environment with less out-gassing. The cone angle of the EOL is determined as 60° to integrate a spectrometer in the UHV LV-SEM and in a large size and a higher tilt angle of the sample. Through the optimization with the simulations, the EOL achieves the minimized spherical and chromatic aberration coefficients of 0.05 and 0.03 mm at the sample side, respectively, at the landing energy of 50 eV and the shortest working distance (WD) of 1 mm for high-resolution imaging. In addition, the probe diameter of the optimized EOL is 2.3 nm at 1 keV and 5.7 nm at 50 eV with a WD of 1 mm and a probe current of 10 pA, which are comparable to previously studied compound objective lenses with magnetic and electrostatic lenses. Using a longer WD of 4 mm for analysis, the probe diameter was 5.4 nm at 1 keV and the SE detection efficiency was 83.3 % owing to the separated scintillator detector structure from the booster electrode. These results imply that the optimized EOL has the potential to be applied to a high-performance UHV LV-SEM for the surface imaging and analysis with a simple system configuration.

Low Energy Large Scan Field Electron Beam Column for Wafer Inspection

Optimization of the Cavity Beam-Position Monitor System for the Shanghai Soft X-ray Free-Electron Laser User Facility

High-Resolution Low-Voltage Electron-Optical System for Very Large Specimens

Design and optimization of a conical electrostatic objective lens of a low-voltage scanning electron microscope for surface imaging and analysis in ultra-high-vacuum environment

A Combined Objective Lens-Energy Analyser for Electron Beam Testing of IC

Whole column fluorescence imaging on a microchip by using a programmed organic light emitting diode array as a spatial-scanning light source and a single photomultiplier tube as detector.

A Fully Solid-State Beam Scanner for FMCW LiDAR Application

A Large-Sample Atomic Force Microscope Observing in Both Air and Liquid

A Novel Atomic Force Microscope Operating in Liquid with Open Probe Unit and Optimized Laser Tracking System

Wave Optical Modeling of the SEM Column From Source to Specimen

Design of Electrostatic Deflectors Applied in DY-2001A Electron Beam Lithography System

Electron Optic Design of Arrayed E-Beam Microcolumns Based Systems for Wafer Defects Inspection

Wide-angle high-precision electronically controlled continuous beam scanning implementation based on MLAS cascaded AFOC

Electron optics of microlenses with inclined beams

18.2 Nm Schwarzschild Microscope for Diagnostics of Hot Electron Transport

Advanced Detector Signal Acquisition and Electron Beam Scanning for High Resolution SEM Imaging.

Investigation and Discovery of the Integration of FEOL Process by Electron Beam Inspections

Combined Electric Field and Near-Field Scanning Optical Microscopy: Modification of Silicon Surfaces

A Comparative Evaluation of the Intensities, Spectral Resolution, and Overall Time of Acquisition Achievable by SEM-based Parallel Beam WDS and SEM-based Rowland Circle WDS

Study on a Large-scale Scanning Three-dimensional Lens Structure of IPC-208B AFM