Abstract:The solid-state processing and utilization of light-metal-based composites align with green policies by reducing the weight of components and employing lower processing temperatures compared to traditional metallurgical methods. This study explores the incorporation of SiC particles at concentrations of 5 and 10 wt.% into an Al4Cu matrix through powder mixing, compaction at 235 MPa, hot extrusion, and sintering at 600 °C in a nitrogen atmosphere. The resulting microstructure, hardness, compressive strength, and flexural strength of the composites were evaluated. During extrusion, the composite underwent plastic deformation, leading to cracking and fragmentation of the SiC particles within the matrix. Therefore, evenly distributed reinforcing particles with a diameter much smaller than the originally introduced ceramic particles were observed. Recrystallization also occurred, with Al 2 Cu precipitates forming on grain boundaries and nanosized Al 2 O 3 oxides observed in porous areas and at matrix-reinforcement interphase boundaries. The composite containing 5 wt.% SiC exhibited the highest compressive strength of 305 MPa, while the composite with 10 wt.% SiC achieved the highest flexural strength of 889 MPa. However, non-deformable SiC particles crack before reaching maximum strength due to stress concentration at their sharp edges, initiating microcracks in the matrix. Microstructural analysis further revealed that SiC particles tend to crack during hot extrusion, reducing their effectiveness in stress transfer. The hardness remained constant at 78 HV1, irrespective of SiC content. These findings demonstrate that the addition of SiC particles significantly enhances the mechanical properties of Al4Cu composites, making them promising materials for lightweight and high-strength applications.

Mechanical properties of hot-pressed Al2O3/SiC composites

Microstructure and Mechanical Properties of Hot-Pressed Al2O3–mullite–ZrO2–SiC Composites

Study on the mechanical properties and microstructure of Al2O3/nano-SiC multiphase ceramics

Effects of residual stress and intragranular particles on mechanical properties of hot-pressed Al2O3/SiC ceramic composites

Microstructure and mechanical properties of Ti3(Al,Ga)C2/Al2O3 composites prepared by in situ reactive hot pressing

Aqueous Processing, Hot-Pressing and Mechanical Properties of Silicon Carbide with Al2O3 and Y2O3

Effects of SiC contents on the microstructure and mechanical properties of Al4SiC4–SiC ceramic composites

Effect of sintering temperature on microstructure and mechanical properties of Al2O3/TiAl in situ composites

Effect of Sintering Temperature on Microstructure and Mechanical Properties of Al2O3/TiAl In-Situ Composites

Hot pressing of SiC additivated with Al2O3 and Y2O3

Mechanical Properties and Microstructure of Al<sub>2</sub>O<sub>3</sub>-Ti<sub>3</sub>SiC<sub>2</sub> Ceramic Composites

Interfacial Regulation and Fracture Mechanism of Al–Si/SiC Composites Infiltrated under Super-Gravity Field

Hot extrusion of SiCp/Al-Cu composites: optimizing mechanical properties through microstructural control

Machinable and mechanical properties of sintered Al 2 O 3 -Ti 3 SiC 2 composites

Study on the Performance for Silicon Carbide Ceramics by Hot-pressing Sintering

Fabrication of Al2O3–Ti3SiC2 Composites and Mechanical Properties Evaluation

Structure and properties of fine diameter continuous SiC ceramic fiber reinforced Al matrix composites

Si3N4-SiC ceramic nanocomposites

Study on Mechanical Properties of Hot Pressing Sintered Mullite-Zro2 Composites with Finite Element Method

Microstructure and mechanical properties of machinable Al2O3/LaPO4 composites by hot pressing

Preparation and mechanical properties of SiC whisker-reinforced alumina