Abstract:The crystal plasticity finite element modeling (CPFEM) is realized in commercial finite element code ABAQUS with UMAT subroutine on the basis of the crystal plasticity theory of rate dependent polycrystal constitutive relations in the mesoscopic scale. The initial orientations obtained by electron backscatter diffraction (EBSD) are directly input into the CPFEM to simulate the mechanical response of polycrystalline 1050 pure Al in uniaxial tensile deformation. Two polycrystal models and two tensile strain rates were used in the simulations. The stress-strain curves of tensile deformation were analyzed. The predictions and the corresponding experiment result show reasonable agreement and slight deviation with experiments. The flow true stress of strain rate 0.01 s(-1) is higher than that of strain rate 0.001 s(-1). At the strain less than 0.05, the stress saturated rate of the experiment is higher than the simulated results. However, the stress saturated rate of the experiment becomes gentler than the corresponding simulated predictions at the strain over 0.05. Also, necking was simulated by the two models, but the necking strain is not well predicted. Tensile textures at strain 0.25 were predicted at the low strain rate of 0.001 s(-1). The predictions are in good accord with the experimental results. (C) 2008 University of Science and Technology Beijing. All rights reserved.

Modeling and Experiment of Deformation Texture Development for Pure Al by CPFEM with EBSD Data

Crystal Plasticity Finite Element Modelling of BCC Deformation Texture in Cold Rolling

Modeling Uniaxial Tensile Deformation of Polycrystalline Al Using CPFEM

Crystal Plasticity Modeling of Texture Evolution and Heterogeneity in Equal Channel Angular Pressing of Aluminum Single Crystal

Modeling Texture Development During Cold Rolling of IF Steel by Crystal Plasticity Finite Element Method

Crystal Plasticity Finite Element Modeling Uniaxial Compression of Pure Al

Modeling Texture Evolution During ECAP of Copper Single Crystal by Crystal Plasticity FEM

Simulation of Texture Evolution During Plastic Deformation of FCC, BCC and HCP Structured Crystals with Crystal Plasticity Based Finite Element Method

Effect of Hardening Models on the Prediction of Deformation Textures for Polycrystalline

A New Quantitative Relation Between Deformation Textures and Corresponding Mechanical Properties of FCC Metals

Crystal Plasticity Investigation of Texture Evolution of Al Single Crystal During Extrusion Through a Bent Channel

Prediction of texture evolution under varying deformation states through crystal plasticity finite element method

Texture Evolution of Polycrystalline Aluminum During Rolling Deformation Ii. Theoretical Simulation

Formation of Deformation Textures in Face-Centered-Cubic Materials Studied by In-Situ High-Energy X-Ray Diffraction and Self-Consistent Model

Deformation Mechanism of Cold Ring Rolling in View of Texture Evolution Predicted by a Newly Proposed Polycrystal Plasticity Model

Crystal Plasticity Finite Element Modeling of Necking of Pure Aluminum During Uniaxial Tensile Deformation

Texture Evolution and Inhomogeneous Deformation of Polycrystalline Cu Based on Crystal Plasticity Finite Element Method and Particle Swarm Optimization Algorithm

Crystal Plasticity Investigation of Friction Effect on Texture Evolution of Al Single Crystal During ECAP

Theoretical Analysis of Texture Evolution in Cold Rolling Process of Single Crystal Aluminum

Texture Evolution Prediction of 2219 Aluminum Alloy Sheet under Hydro-Bulging Using Cross-Scale Numerical Modeling

Modeling of Heterogeneous Tensile Deformation of Polyscrystalline Aluminum