Abstract:To address the issue of strength and toughness inversion in traditional metal matrix composites, which are reinforced by uniformly distributed ceramic particles, this research developed a novel space bundle configuration of reinforced iron matrix composite using tungsten wire (W) and tungsten carbide (WC). This composite was prepared using a lost foam casting process combined with in-situ reaction. Microstructural analysis revealed that WC particles are distributed along the tungsten wire, with larger particles at the center and smaller ones at the edges. The formation of the reinforcement occurs in two stages: first, a solid-liquid reaction between the solid tungsten wire and molten iron during the lost foam casting process, promoting WC formation at high temperatures and carbon potential; second, an in situ solid-solid reaction where Fe diffuses and Fe3W3C decomposes, forming a composite structure of WC and α-Fe. The composite obtained at 1100 °C for 9 h exhibited a compressive strength of 836.59 MPa and a fracture strain of 18.69 %, representing increases of 48.46 % and 48.69 % respectively compared to gray cast iron (GCI). The (W) WC/Fe bundle reinforcement effectively enhances the strength and toughness of the composite through the high volume fraction and gradient distribution of WC particles, combined with the synergistic effect of α-Fe. This research provides a new strategy for improving the mechanical properties of composite materials and resolving the issue of strength-toughness inversion.

Reaction-formed W2B5/C composites with high performance

Microstructure and properties of the C/W2B5 composites fabricated by reaction hot-pressing

MECHANICAL AND TRIBOLOGICAL PROPERTIES OF C/W2B5 COMPOSITES FABRICATED BY REACTION HOT-PRESSING

Dense Submicron-Sized ZrC – W Composite Produced by Reactive Melt in Fi Ltration at 1200 ° C

Effect of TiB_2 content on microstructure and mechanical properties of in-situ fabricated TiB_2/B_4C composites

Mechanical Properties and Thermal Shock Performance of W-Y2O3composite Prepared by High-Energy-rate Forging

Tribological behavior of W2B5 particulate reinforced carbon matrix composites

Improvement in air oxidation resistance of carbon materials by W2B5 ceramic reinforcement

Dual Plate-Like Grains of (ti, Zr)B2 and W2B5 Toughened Solid Solution Composites Fabricated Via In-Situ Reaction Spark Plasma Sintering of (ti, W)C and ZrB2 Powders

Microstructure and Properties of ZrC–W Composite Fabricated by Reactive Infiltration of Zr2Cu into WC/W Preform

High-performance B4C-YB4 composites fabricated with Y2O3 additive via hot-pressing sintering

Wear Performance of C–W2B5 Composite Sliding Against Bearing Steel

Preparation and Properties of B4c-Zrb2-Sic Ceramic Composites

Fe–W–C Thermodynamics and in Situ Preparation of Tungsten Carbide-Reinforced Iron-Based Surface Composites by Solid-Phase Diffusion

High-performance B4C matrix composites fabricated from the B4C–Si–CeO2 system via reactive hot pressing

Structure and mechanical properties of hot-pressed B4C-NdB6 composites

Preparation and Formation Mechanism of (W) WC/Fe Bundle Reinforced Iron Matrix Composites

Influence of W2B5 addition on microstructure and thermoelectric properties of B4C ceramic

Microstructures and Properties of WC-10 wt.%CoCrFeNiAlx Composite Cemented Carbides

Processing and Characteristics of TiB 2 Toughened B-Ti-C Composites

B4C‒TiB2 composite with modified microstructure and enhanced properties from optimal size coupling of raw powders