Abstract:WC reinforced WCu composites have excellent wear resistance and high-temperature strength, and can replace conventional WCu composites in special applications. In this work, WCu composites with core-shell structure are fabricated through a novel microwave-heating salt-bath carbonization (MSC) and infiltration method, using graphite as the carbon source. The MSC behavior of W particles and the influence of the graphite content on the microstructure and properties of the WCu composites are investigated. The results show that WC is successfully coated on the surface of W particles by the MSC method. The addition of an appropriate amount of graphite to W powders can improve the high-temperature mechanical properties and wear resistance of the WCu composites. Compared with conventional WCu composites, the WCu composites with 0.9 wt% graphite have higher thermal conductivity (245 W/(m·K)), higher hardness (293.8 HV), higher bending strength (1089.4 MPa), and higher compressive strength (410 MPa| 600°C ). The addition of graphite also significantly improved the wear resistance of the WCu composites. The average coefficient of friction (CoF) and wear rates (WR) of WCu9 composites are 0.51 and 5.37 × 10 −6 mm 3 N −1 m −1 , respectively. The WC reinforced WCu composites prepared in this work provide an excellent approach to improve the wear resistance and high-temperature properties of guide plates in guide devices.

MECHANICAL AND TRIBOLOGICAL PROPERTIES OF C/W2B5 COMPOSITES FABRICATED BY REACTION HOT-PRESSING

Microstructure and properties of the C/W2B5 composites fabricated by reaction hot-pressing

Reaction-formed W2B5/C composites with high performance

Effect of TiB_2 content on microstructure and mechanical properties of in-situ fabricated TiB_2/B_4C composites

Dense Submicron-Sized ZrC – W Composite Produced by Reactive Melt in Fi Ltration at 1200 ° C

Tribological behavior of W2B5 particulate reinforced carbon matrix composites

Wear Performance of C–W2B5 Composite Sliding Against Bearing Steel

Microstructure and Properties of ZrC–W Composite Fabricated by Reactive Infiltration of Zr2Cu into WC/W Preform

Microstructure and mechanical properties of 20Wf/30ZrCp/W composite

High-performance B4C-YB4 composites fabricated with Y2O3 additive via hot-pressing sintering

Microstructures and mechanical properties of B4C‐SiC and B4C‐SiC‐TiB2 ceramic composites fabricated by hot pressing

Fabrication and Characterization of B4C-based Ceramic Composites with Different Mass Fractions of Hexagonal Boron Nitride

A novel approach to fabricate WC reinforced W Cu composites via MSC and infiltration method

Preparation and Properties of B4c-Zrb2-Sic Ceramic Composites

Microstructure and mechanical properties of B4C–TiB2 ceramic composites prepared via a two-step method

FABRICATION AND THERMAL SHOCK RESISTANCE OF THE MACHINABLE BN/B4C COMPOSITE CERAMICS

Preparation of Warm Compacted and Sintered WC/Carbon Steel Composite and Its Wear-Resistance

Effect of B4C particle size and TiB2 content on the mechanical properties of B4C composites and their dynamic mechanical properties

Microstructure and mechanical properties of TiB2–B4C ceramics fabricated by hot-pressing

THE INFLUENCE OF ZrC PARTICLE CONTENT ON THE MECHANICAL PROPERTIES OF TUNGSTEN MATRIX COMPOSITES

B4C-SiC skeleton reinforced graphite composites with excellent mechanical properties