Abstract:A numerical model of an iron bath smelting reduction furnace with side-bottom combined blowing was established to study the influence of blowing arrangements on the stirring effect of the molten pool, and the accuracy of numerical simulation was verified by water model experiment. By comparing the flow field of molten pool with single nozzle, double nozzles (symmetrical and asymmetrical), and four nozzles (symmetrical and asymmetrical), the proportion of dead zone, average turbulent kinetic energy, and mixing time, the results show that asymmetrical bottom blowing is better than symmetrical bottom blowing, and the effect of double nozzles bottom blowing was better than that of four nozzles bottom blowing. The mixing effect is the worst under the condition of single nozzle. When the bottom blowing is asymmetrical with double nozzles, the mixing time is the shortest. Under the condition of double nozzles asymmetrical bottom blowing, when the insertion angle and depth of side lance are larger and deeper, the velocity streamline of molten slag layer is denser and the value is larger; meanwhile, the reflux of molten iron layer is larger, the proportion of dead zone is smaller, and the whole molten pool is fully stirred. When the insertion depth of the side lance is deeper, the gas holdup in the molten pool is greater and the stirring of the molten pool is more intense, while the insertion angle has little effect on the gas holdup. By comparing the influence of different side blowing conditions on the slag layer, it is found that the slag layer is divided into two layers by double-layer side lance, with the critical surface of the slag layer at about 200–260 mm from the bottom, and the insertion depth of the lower side lance has a greater influence on the layering of the slag.

Numerical Simulation on Melt Flow with Bubble Stirring and Temperature Field in Aluminum Holding Furnace

Numerical simulation of combustion and melting process in an aluminum melting Furnace: A study on optimizing stacking mode

Numerical Simulation of Temperature Field of Melting Pools with Different Horizontal Width in the Bottom of Float Glass Furnace

Multiphysics Numerical Simulation Model and Hydraulic Model Experiments in the Argon-Stirred Ladle

Numerical analysis of thermohydraulic behavior in a directional solidification furnace

Numerical Simulation of Magnetic Field Distribution in Aluminum Melting Furnace with Electromagnetic Stirring

Numerical Simulation of Bubble and Velocity Distribution in a Furnace

Numerical Simulation Study on Immersed Side‐Blowing in C‐H2 Smelting Reduction Furnace

Mathematical Modelling for Furnace Design Refining Molten Aluminum

Numerical Simulation of Bottom-Blowing Stirring in Different Smelting Stages of Electric Arc Furnace Steelmaking

Three-dimensional Numerical Simulation of Flow and Splash Behavior in an Oxygen Coal Combustion Melting and Separating Furnace

Numerical Calculation of Flow Field Inside TiAl Melt During Rectangular Cold Crucible Directional Solidification

Numerical Simulation on Multiple Physical Fields Behaviors in Billet Continuous Casting with Different Stirrer Positions

Numerical simulation on flow and heat transfer in twin roll strip casting and rolling molten pool with side dams vibrating

Melt convection and macrosegregation in the vacuum arc remelted Ti2AlNb ingot: Numerical methods and experimental verification

Numerical Simulation of Multiphase Flow in Steel Continuous Casting Mold Using a Novel Euler–Euler–Lagrange Method

Numerical Simulation of Heat Transfer Behavior in Hot Spot Zone of Converter Molten Bath

Numerical simulation of flow characteristics of side-bottom combined blowing in iron bath reactor

Numerical simulation of high pressure gas quenching of H13 steel

Numerical investigation of bubble behavior and multiphase flow in ladle using purging plug with inclined slit designs

Motion and mass transfer models for single bubble in an aluminum melt under a compound field of ultrasonic and rotating flow