Abstract:Droplet splashing behavior caused by the top blowing supersonic jets impacting the liquid metal surface significantly affects the decarburization efficiency and refractory erosion during the basic oxygen furnace (BOF) steelmaking process. However, simulating the mass and size of splashing droplets is challenging because the droplet size differs by multiple orders of magnitude from the molten bath. Herein, a hybrid model (VOF-to-DPM) coupling the volume of fluid model (VOF) and discrete phase model (DPM) was combined with the adaptive mesh refinement (AMR) technique to successfully achieve high-resolution and quantitative capture of splashing droplets. The simulation results are in good agreement with the droplet splashing rate calculated by the theoretical formula based on the Blowing number ( N B ) within the allowable error range. The generation mechanisms of splashing droplets caused by single-hole and multiple-hole jets impacting the liquid surface were clarified. Furthermore, the effects of oxygen lance height and top blowing flow rate on the total droplet mass, mass and percentage of droplets sprayed on the furnace wall, and the droplet size were also investigated. It was revealed that with the decrease of the oxygen lance height, the total droplet mass increases and then decreases, and the droplet size increases. As the top blowing flow rate increases, the total mass and size of droplets both tend to increase. The proportion of droplets sprayed on the furnace wall increases sequentially when the impact cavities are in the penetrating mode, splashing mode, and quasi-dimpling mode. Moreover, the relationship between the cavity morphology and the droplet splashing was quantitatively characterized. As the modified cavity shape index ( I cm ) increases, the droplet splashing mass increases then decreases and finally increases. The change in cavity mode is the main factor affecting the droplet splashing behavior.

Three-dimensional Numerical Simulation of Flow and Splash Behavior in an Oxygen Coal Combustion Melting and Separating Furnace

Three-dimensional Numerical Simulation of Velocity Field Distribution in an Oxy-Coal Combustor-Melter-separator Furnace

OXYGEN-ENRICHED COMBUSTION IN A HORIZONTAL FURNACE AND THREE- DIMENTIONAL NUMERICAL SIMULATION TEST THEREOF

Numerical Simulation of Gas-Liquid Multi-Phase Flows in Oxygen Enriched Bottom-Blown Furnace

Numerical Simulation for the Splashing Behavior in an Oxygen Converter Process

Numerical Simulation of Temperature and Velocity Field in All-Oxygen Combustion

Numerical Simulation of Flow and Combustion Process in the Tangentially Fired Furnace of a 200 MW Pulverized Coal Boiler

Numerical Simulation of the Flow and Combustion Processes in a Three-Dimensional, W-Shaped Boiler Furnace

Three-Dimensional Simulation of the Pulverized Coal Combustion Inside Blast Furnace Tuyere

Experimental study and numerical simulation on the gas-solid two-phase flow field in the furnace of a 300MW tangentially fired utility boiler

Three-dimensional Simulation of Flow and Combustion for Pulverised Coal Injection

Numerical Simulation on 200MWe Tangential-fired Boiler for Oxy-firing Characteristics

Numerical Simulation of the Interaction Between Supersonic Oxygen Jets and Molten Slag–Metal Bath in Steelmaking BOF Process

Numerical Simulation Study on Immersed Side‐Blowing in C‐H2 Smelting Reduction Furnace

Three-dimensional Modelling of Coal Combustion in Blast Furnace

Numerical Simulation and Experimental Study on A Novel Kiln Burner

Numerical Simulation of O2／CO2 Recycled Flue Gas Combustion in a 300 MW Boiler

Mathematical Simulation on Flow Behavior of Immersion Side-blowing in Iron-bath Smelting Reduction Furnace

Numerical Simulation of Bubble and Velocity Distribution in a Furnace

Numerical Simulation of Droplet Splashing Behavior in Steelmaking Converter Based on VOF-to-DPM Hybrid Model and AMR Technique

Numerical simulation of multiphase flow in bottom-blowing furnace for lead smelting