Abstract:The silicon carbide (SiC) inverter brings great advantages to the motor drive systems of new energy vehicles; however, severe challenges to the bearings also happen. The high dc bus voltage and switching frequency of SiC inverter can increase the discharge frequency and energy when the bearing grease film collapses. As a result, the bearing suffers severe electric corrosion, and the service life of the motor drive system can be shortened. In this paper, the characteristics of common-mode voltage and bearing voltage are analyzed, firstly under space vector pulse width modulation (SVPWM). After that, the common-mode equivalent circuit model of the motor drive system is established. The frequency characteristics of bearing voltage are revealed, and the safe working area is determined. Then, the frequency characteristics of bearing voltage and current are verified based on IGBT and SiC inverters in experiments. After that, by designing a common-mode filter, the bearing voltage and current are significantly attenuated. Furthermore, the active zero state PWM (AZSPWM) is adopted to reduce the common-mode voltage from the inverter. At the same time, combined with the common-mode filter, the bearing voltage and current are further reduced. The experimental results show that the switching frequency has a decisive effect on the amplitude of bearing voltage and current. The bearing voltage can be attenuated to around half of the reference bearing voltage by using the common-mode filter and AZSPWM strategy, respectively. The combination of the common-mode filter and AZSPWM strategy can reduce the bearing voltage to around one-fourth of the reference bearing voltage, which can effectively reduce the breakdown time and discharge energy of the grease oil film.

Design of Common-Mode and Differential-Mode Voltage dv/dt Filter at PWM Inverter Output Terminals

A New Approach to Mitigate CM and DM Voltage Dv/dt Value in PWM Inverter Drive Motor Systems

Design of a Passive Filter to Reduce Common-Mode and Differential-Mode Voltage Generated by Voltage-Source PWM Inverter

Design of Over-Voltage Filter at PWM Inverter Output Terminals

A Novel Inverter-Output Passive Filter for Reducing Both Differential- and Common-Mode $dv/dt$ at the Motor Terminals in PWM Drive Systems

Common-Mode Filter Design for a Transformerless ZVS Full-Bridge Inverter

Modeling of Common-Mode Current in Motor Cable of Inverter-Fed Motor Drive System

Extraction of Common-Mode Impedance of an Inverter-Fed Induction Motor

Filter Design of Restraining Over-Voltage and Bearing Current in Induction Motor Fed by Pwm Inverter

Characterizations of PM Synchronous Motor with an Integrated Common-Mode Voltage Filter

Design and Multi-constraint Evaluation of Passive Dv/dt Filter for SiC-based Motor Drives

High-Frequency Modeling and Filter Design for PWM Drives with Long Cables

Common Mode Voltage and Shaft Voltage Suppression on a Three-Level NPC Inverter System Applying Improved SHEPWM

A Novel Filter Topology with Active Motor CM Impedance Regulator in PWM ASD System

Influence of Motor Cable on Common-Mode Currents in an Inverter-Fed Motor Drive System

Analysis and Utilization of Common-mode Voltage in inverters for Power Supply

A Modulation Method to Eliminate Common-mode Voltage of Dual Three-Phase Motor

Impact of reduced common mode voltage PWM and common mode inductor on EMI characteristics of an inverter-driven motor

Research on Analysis and Suppression Methods of the Bearing Current for Electric Vehicle Motor Driven by SiC Inverter

Modeling of Common-Mode Impedance of an Inverter-Fed Induction Motor from Online Measurement

A study of motor-end EMI filter on output common-mode noise suppression in DC-fed motor drive system