Abstract:Wire crimping, a process commonly used in the automotive industry, is a solderless method for establishing electrical and mechanical connections between wire strands and terminals. The complexity of predicting the final shape of a crimped terminal and the imperative to minimize production costs indicate the use of advanced numerical methods. Such an approach requires a reliable phenomenological elasto-plastic constitutive model in which material behavior during the forming process is described. Copper alloy sheets, known for their ductility and strength, are commonly selected as terminal materials. Generally, sheet metals exhibit significant anisotropy in mechanical properties, and this phenomenon has not been sufficiently investigated experimentally for copper alloy sheets. Furthermore, the wire crimping process is conducted at higher velocities; therefore, the influence of the strain rate on the terminal material behavior has to be known. In this paper, the influence of the strain rate on the anisotropic elasto-plastic behavior of the copper alloy sheet CuFe2P is experimentally investigated. Tensile tests with strain rates of 0.0002 s−1, 0.2 s−1, 1 s−1, and 5.65 s−1 were conducted on sheet specimens with orientations of 0°, 45°, and 90° to the rolling direction. The influence of the strain rate on the orientation dependences of the stress–strain curve, elastic modulus, tensile strength, elongation, and Lankford coefficient was determined. Furthermore, the breaking angle at fracture and the inelastic heat fraction were determined for each considered specimen orientation. The considered experimental data were obtained by capturing the loading process using infrared thermography and digital image correlation techniques.

Experimental Research on Strain Rate Sensitivity of Automotive Steel Sheet

Effect of Loading Rate on Tensile Properties of Automotive Steel Sheet

Effect of Strengthening Mechanism on Strain-Rate Related Tensile Properties of Low-Carbon Sheet Steels for Automotive Application

Experimental Research of Prestrain Effects on Mechanical Behavior of Dual Phase Steel

Effect of Material Anisotropy on the Mechanical Response of Automotive Steel under High Strain Rates

Effect of Pre-strain and Strain Rate on Deformation and Fracture Behavior of Automotive Grade Interstitial Free Steel Sheets

Preliminary Studies on Strain Rate Dependence of Laser Shock Forming

Testing and Modeling the Effect of Strain-Rate on Plastic Anisotropy for A Traditional High Strength Steel

Strain Rate Dependence of Strengthening Mechanisms in Ultrahigh Strength Lath Martensite

Rate-Dependent Behavior And Constitutive Model Of Dp600 Steel At Strain Rate From 10(-4) To 10(3) S(-1)

Extended Stress–Strain Characterization of Automotive Steels at Dynamic Rates

Tensile Mechanical Behaviour of Ultra-High Strength Cold Rolled Dual Phase Steel DP1000 at High Strain Rates

Effect of Mn content and strain rate on mechanical properties of high-C high-Mn austenitic steel

Rate-dependent behavior and constitutive model of DP600 steel at strain rate from 10−4 to 103s−1

Influence of Pre-Straining and Heating on Strain-Rate Sensitivity of AA5182-O

Anisotropy Study of Thin Metallic Sheets with Strain Measurement of Digital Speckle Correlation

STUDY ON THE RATE-DEPENDENT EXPERIMENT AND CONSTITUTIVE MODEL OF HIGH STRENGTH STEEL DP600 BASED ON KHAN-HUANG MODEL

Strain Rate Sensitivity of Ductility in a Fe-28Al Alloy under Tensile Impact

Effect of strain rate on microstructure and mechanical properties of spray-formed Al–Cu–Mg alloy

Strain Rate Effect on the Fracture Behavior of the AA5754 Aluminum Alloy

Experimental Investigation of Strain Rate Influence on Anisotropy of Uniaxial Tensile Mechanical Properties of CuFe2P Alloy Sheet