Abstract:The ductility of metallic materials is recognized to be significantly affected by stress state and strain rate. However, systematic investigations on the impacts of stress state and strain rate on ductile behavior are infrequent, and only a minority of fracture models can consider both effects concurrently. This work aims to systematically investigate the ductile response of Ti6Al4V alloy over a broad spectrum of stress states and strain rates and to propose a ductile model that incorporates the coupled influence of stress state and strain rate. First, five types of specimens were employed to obtain distinct stress states. Then, the fracture strain of material was ascertained for strain rate spanning from 10 −3 /s to 10 3 /s, stress triaxiality ranging from -0.7 to 0.4, and Lode angle parameter varying from -1 to 1 using a combined experimental-numerical method. It was found that over a broad spectrum of stress states, the relation between fracture strain versus stress state is not monotonic, and the fracture strain reduces as strain rate increases. Utilizing the experimental data, a novel ductile fracture model incorporating the stress triaxiality, Lode angle parameter and strain rate was established and embedded into the ABAQUS/Explicit through the user material subroutine VUMAT. Finally, a validation test was conducted to demonstrate the validity of the proposed model. The results indicate the satisfactory correlation between experiment and calculation for fracture displacement and fracture morphology, which illustrates that the proposed model can predict the ductile behavior across a wide spectrum of stress states and strain rates. This work provides a definite theoretical guidance for the optimization design and safety evaluation of Ti-6Al-4V alloy structural components.

Strain Rate Sensitivity of Ductility in a Fe-28Al Alloy under Tensile Impact

Strain Rate Sensitivity of Ductility and Fracture Behaviors in a Fe–28Al Alloy

Strain Rate Sensitivity of Tensile Properties in Ti–47Al–2Mn–2Nb–0.8TiB2 Alloy

Dynamic Testing of Materials with the Rotating Disk Indirect Bar-Bar Tensile Impact Apparatus

Dynamic Mechanical Behavior and Numerical Simulation of 6013-T4 Aluminum Alloy at Different Temperatures and Strain Rates

A rate-dependent damage mechanics model for predicting plasticity and ductile fracture behavior of sheet metals at high strain rates

Study of dynamic mechanical behavior of 1060-H112 aluminum alloy: Experimental and numerical simulation

Dynamic Behavior of Aluminum Alloy Aw 5005 Undergoing Interfacial Friction and Specimen Configuration in Split Hopkinson Pressure Bar System at High Strain Rates and Temperatures

An Investigation on Dynamic Tensile Properties of TiAl Intermetallic Alloy

Design of a Novel High-Speed Tensile Method for Testing the High Strain Rate Tensile Behavior of Aluminum Alloys.

Strain-Rate-Dependent Tensile Response of Ti–5Al–2.5Sn Alloy

Effect of strain rate on behaviour of Fe3Al under tensile impact

Dynamic Simulation Analysis of the Mid-Strain-Rate Tensile Testing Machine

Dynamic Tensile Testing of Based and Welded Automotive Steel

Effect of Strain Rate and Temperature on Dynamic Mechanical Behavior and Microstructure Evolution of Ultra-High Strength Aluminum Alloy

Effects of strain rate and manganese addition on room temperature ductility of FeAl

Dynamic Compressive Mechanical Behavior and Microstructure Evolution of Rolled Fe-28Mn-10Al-1.2C Low-density Steel

Coupled effect of stress state and strain rate on ductile fracture of Ti6Al4V alloy

Dynamic tensile properties of Ti-47Al-2Mn-2Nb-0.8TiB2 alloy

Ductile Fracture Initiation of Anisotropic Metal Sheets

Strain Rate Sensitivity and Adiabatic Shear Deformation of an Advanced Al-Mg Alloy