Abstract:The properties and applications of CNT have been studied extensively since Iijima discovered them in 1991[1,2]. They have exceptional mechanical properties and unique electrical property, highly chemical stability and large specific surface area. Thus far, they have widely potential applications in many fields. They can be used as reinforcing materials in composites[3], field emissions[4], hydrogen storage[5], nanoelectronic components[6], catalyst supports[7], adsorption material and so on. However, the study on the potential application of CNT, environmental protection field in particular, was hardly begun.Long[8] et al. reported that CNT had a significantly higher dioxin removal efficiency than that of activated carbon. The Langmuir adsorption constant is 2.7 × 1052, 1.3 × 1018 respectively. The results indicated that CNT is potential candidate for the removal of micro-organic pollutants. However, the reports on the CNT used as fluoride and heavy metal adsorbent are seldom.In this paper, A novel material, alumina supported on carbon nanotubes (Al2O3/CNT), was prepared from carbon nanotubes and Al(NO3)3. X-ray diffraction (XRD) spectra demonstrate that alumina is amorphous, and scanning electron microscope (SEM) images show that CNT and alumina are homogeneously mixed. Furthermore, the fluoride adsorption behavior on the surface of Al2O3/CNT has been investigated and compared with other adsorbents. The results indicate that Al2O3/CNT has a high adsorption capacity, with a saturation adsorption capacity of 39.4 mg/g. It is also found that the adsorption capacity of Al2O3/CNT is 3.0～4.5 times that of γ-Al2O3while almost equal to that of IRA-410 polymeric resin at 25 ℃. The adsorption isotherms of fluoride on Al2O3/CNT is fit the Freundlich equation well, optimal pH ranging from 5.0 to 9.0.Also in this paper, a novel material, modified carbon nanotubes (CNT), was prepared from carbon nanotubes and HNO3 under boiling condition. Infrared spectroscopy (IR) demonstrates that hydroxyl (-OH) and carbonyl (-C=O) f

Nmr and Ir Study of Fluorobenzene and Hexafluorobenzene Adsorbed on Alumina

19F mas NMR and FTIR analysis of the adsorption of alkali metal fluorides onto alumina

Surface modification of fluorinated aluminas: Application of solid state NMR spectroscopy to the study of acidity and surface structure

FT-IR Spectroscopic Study on Basicity of Alumina with Adsorption of Boric Acid Trimethyl Ester

Investigation of Fluorine Adsorption on Nitrogen Doped Mgal2o4 Surface by First-Principles

19F Magic Angle Spinning NMR Reporter Molecules: Empirical Measures of Surface Shielding, Polarisability and H-bonding

Adsorption of thioether molecules on an alumina thin film

Fluorination of an Alumina Surface: Modeling Aluminum-Fluorine Reaction Mechanisms

Catalytic Properties of Fluorinated Alumina for the Production of Dimethyl Ether

Treatment effect on the adsorption capacity of alumina for removal fluoride

CO adsorption on pure, defective and mixed composition AlF3 and MgF2 surfaces

An Investigation of the Roles of Surface Aluminum and Acid Sites in the Zeolite Mcm-22

Studies on the Preparation of Alumina Supported on Carbon Nanotubes and Defluorination from Absorbed Water

Preparation of alumina supported on carbon nanotubes and its application in fluoride adsorption from an aqueous solution

Adsorption and Reactions of Hfc-134a Gas on the Nascent Surface of Alumina

The structure and phase transformations in fumed transition alumina by X-ray diffraction and solid-state NMR

The adsorption of Na2[Cu(CN)3] onto alumina: The existence of both crystalline and solvated forms on the surface

Fluoride and Lead Adsorption on Carbon Nanotubes

Adsorption of Fluoride Onto Different Types of Aluminas

Insights into the mechanism of fluoride adsorption over different crystal phase alumina surfaces

Modelling the adsorption of fluoride onto activated alumina in the presence of other ions