Abstract:The properties and applications of CNT have been studied extensively since Iijima discovered them in 1991[1,2]. They have exceptional mechanical properties and unique electrical property, highly chemical stability and large specific surface area. Thus far, they have widely potential applications in many fields. They can be used as reinforcing materials in composites[3], field emissions[4], hydrogen storage[5], nanoelectronic components[6], catalyst supports[7], adsorption material and so on. However, the study on the potential application of CNT, environmental protection field in particular, was hardly begun.Long[8] et al. reported that CNT had a significantly higher dioxin removal efficiency than that of activated carbon. The Langmuir adsorption constant is 2.7 × 1052, 1.3 × 1018 respectively. The results indicated that CNT is potential candidate for the removal of micro-organic pollutants. However, the reports on the CNT used as fluoride and heavy metal adsorbent are seldom.In this paper, A novel material, alumina supported on carbon nanotubes (Al2O3/CNT), was prepared from carbon nanotubes and Al(NO3)3. X-ray diffraction (XRD) spectra demonstrate that alumina is amorphous, and scanning electron microscope (SEM) images show that CNT and alumina are homogeneously mixed. Furthermore, the fluoride adsorption behavior on the surface of Al2O3/CNT has been investigated and compared with other adsorbents. The results indicate that Al2O3/CNT has a high adsorption capacity, with a saturation adsorption capacity of 39.4 mg/g. It is also found that the adsorption capacity of Al2O3/CNT is 3.0～4.5 times that of γ-Al2O3while almost equal to that of IRA-410 polymeric resin at 25 ℃. The adsorption isotherms of fluoride on Al2O3/CNT is fit the Freundlich equation well, optimal pH ranging from 5.0 to 9.0.Also in this paper, a novel material, modified carbon nanotubes (CNT), was prepared from carbon nanotubes and HNO3 under boiling condition. Infrared spectroscopy (IR) demonstrates that hydroxyl (-OH) and carbonyl (-C=O) f

Fluoride and Lead Adsorption on Carbon Nanotubes

Preparation of alumina supported on carbon nanotubes and its application in fluoride adsorption from an aqueous solution

Adsorption of Fluoride from Water by Amorphous Alumina Supported on Carbon Nanotubes

Studies on the Preparation of Alumina Supported on Carbon Nanotubes and Defluorination from Absorbed Water

Adsorption of Fluoride from Water by Aligned Carbon Nanotubes

Removal of Fluoride from Water by Carbon Nanotube Supported Alumina

Lead Adsorption on Carbon Nanotubes

Boosting the Adsorption and Removal of Dye from Water by COOH-functionalized Carbon Nanotubes

Enhanced Adsorptive Removal of Methyl Orange and Methylene Blue from Aqueous Solution by Alkali-Activated Multiwalled Carbon Nanotubes

Surface Characteristics of Modified Carbon Nanotubes and Its Application in Lead Adsorption from Aqueous Solution

Adsorption of Fulvic Acid by Carbon Nanotubes from Water.

Intercalation of Rigid Molecules Between Carbon Nanotubes for Adsorption Enhancement of Typical Pharmaceuticals

Different Morphologies of Carbon Nanotubes Effect on the Lead Removal from Aqueous Solution

Adsorption of Fulvic Acids from Aqueous Solutions by Carbon Nanotubes

Adsorption behavior of HFCO and COF 2 gasses on pristine, Al-doped, and N-doped (8, 0) single-wall carbon nanotubes and pristine aluminum nitride nanotube: A first-principles study

Adsorption of low-concentration carbon dioxide on amine-modified carbon nanotubes at ambient temperature

Competitive Adsorption Of Naphthalene With 2,4-Dichlorophenol And 4-Chloroaniline On Multiwalled Carbon Nanotubes

Adsorption of nitrogen oxides on Al-doped carbon nanotubes: the first principles study

Removal of Cu2+ Ions from Aqueous Solutions by Carbon Nanotubes

Adsorption Performance and Mechanisms of Co2+ Onto Carboxyl-Functionalized Carbon Nanotubes

Are carbon nanotubes promising adsorbents for water treatment ?