Abstract:Solid-state chemiresistive gas sensors have attracted a lot of researchers’ attention during the last half-century thanks to their ability to detect different gases with high sensitivity, low power consumption, low cost, and high portability. Among the most promising sensitive materials, carbon nanotubes (CNTs) have attracted a lot of interest due to their large active surface area (in the range of 50–1400 m2/g, depending on their composition) and the fact that they can operate at room temperature. In this study, single-walled carbon nanotube (SWCNT)-based sensing films were prepared and deposited by spray deposition for the fabrication of gas sensors. For the deposition, various SWCNTs were prepared in deionized water with the addition of specific surfactants, i.e., carboxymethyl cellulose (CMC) and sodium dodecyl sulfate (SDS), which act as dispersing agents to create a suitable ink for deposition. This study aims to elucidate the possible differences in the sensing performance of the fabricated devices due to the use of the two different surfactants. To achieve this goal, all the devices were tested versus ethanol (C2H5OH), carbon monoxide (CO), nitrogen dioxide (NO2), and ammonia (NH3). The produced devices demonstrated high selectivity towards NH3 and NO2. The different sensors, prepared with different deposition thicknesses (from 0.51 nm to 18.41 nm), were tested in dry and wet conditions (40% humidity), highlighting an enhanced response as a function of relative humidity. In addition, sensor performance was evaluated at different working temperatures, showing the best performance when heated up to 150 °C. The best sensing conditions we found were against NO2, sensors with 10 layers of deposition and an operating temperature of 150 °C; in this condition, sensors showed high responses compared those found in the literature (62.5%—SDS-based and 78.6%—CMC-based). Finally, cross-sensitivity measurements showed how the produced sensors are good candidates for the practical and selective detection of NO2, even in the presence of the most important interfering gases identified, i.e., NH3.

Adsorption behavior of HFCO and COF 2 gasses on pristine, Al-doped, and N-doped (8, 0) single-wall carbon nanotubes and pristine aluminum nitride nanotube: A first-principles study

Exploring Carbon Monoxide and Carbon Dioxide Adsorption on (5,5) Aluminum Nitride Nanotubes for Enhanced Sensor Applications: A DFT Study

Adsorption of formamide on pure, Al-, N-doped, and Al/N co-doped (8, 0) single-wall carbon nanotubes: a DFT study

Assessing the gas sensing capability of undoped and doped aluminum nitride nanotubes

The adsorption of CO and NO on (8,0) SWCNT decorated with transition metals: A DFT study as a possible gas sensor

Adsorption of small gas molecules onto boron nitride nanotubes and their Al-, Ga-, Cr- and Fe-doping derivatives for gas sensing, storage, and catalytic properties: Periodic DFT study

Monitoring and sensing of (HF)n linear chain for n = 1–4 on aluminum nitride nanocage in both gas and water phases; computational study

Adsorption of nitrogen oxides on Al-doped carbon nanotubes: the first principles study

Adsorption of Gas Molecules on Graphene Nanoribbons and Its Implication for Nanoscale Molecule Sensor

Theoretical analysis of the absorption of CO2 and CO on pristine and Al-doped C3B.

Detection of cyanogen (NCCN) on Ga-, In-, and Tl-doped aluminium nitride (AlN) nanotube: insights from quantum chemical calculations

Nitrogen-phosphorus codoped carbon nanotube sponges for detecting volatile organic compounds: experimental and DFT calculations

Novel Insights into the Unique Intrinsic Sensing Behaviors of 2D Nanomaterials for Volatile Organic Compounds: from Graphene to MoS2 and Black Phosphorous

Computational insights into the electronic structure and adsorption properties of CN, CNCl, and NO2 on metal (Na, Zn, and Al,) doped fullerene surfaces

Silicon Carbide Nanotubes As Potential Gas Sensors for CO and HCN Detection

A Flexible NO2 Gas Sensor Based on Single-Wall Carbon Nanotube Films Doped with a High Level of Nitrogen

The Influence of Surfactants on the Deposition and Performance of Single-Walled Carbon Nanotube-Based Gas Sensors for NO2 and NH3 Detection

Fermi Level Regulation of Single-Walled Carbon Nanotubes by Metal Chloride Doping for Enhanced No2 Sensing Performance

Investigating the adsorption behavior of cyano radical on zigzag aluminum nitride and aluminum phosphide nanotubes: A DFT study

Adsorption of Fluoride from Water by Aligned Carbon Nanotubes

Adsorption Of Hydroxyl- And Amino-Substituted Aromatics To Carbon Manotubes