Abstract:A TD-split basal texture with two peaks highly tilted from the normal direction (ND) towards the transverse direction (TD) is usually developed in Mg-Zn-Ca plates and can effectively improve ductility and formability. In the present study, the texture evolution during cold rolling and subsequent annealing of a Mg-2Zn-1Ca plate with initial TD-split texture was investigated, and new insights into the mechanisms of texture evolution were obtained. The results show that a dumbbell-shaped basal texture transformed into an elliptical shape after 41% cold rolling. The random distribution of prismatic planes became preferred with largely parallel to the rolling direction (RD). Crystal plasticity simulations revealed that basal slip was the predominant deformation mode, and inclined basal poles toward the ND. The activation of other non-basal slips would retard this tendency. Prismatic slip with a relative activity of 20% to 30% preserved the pre-existing TD-split texture after a high rolling reduction of 41%. Pyramidal slip prevented the formation of basal fiber and lead to a spreading of basal poles toward the RD mainly at strains over 29%. After full recrystallization, the elliptical TD-split basal texture became a dumbbell-shaped TD-split texture. Grain nucleation was observed at grain boundaries (GBN mechanism), within deformation twins (DTN mechanism), and near precipitates (PSN mechanism). GBN and DTN mainly developed a TD-split basal-texture. Instead of the formation of random orientations as considered previously, PSN produced a TD-split basal-texture, and the basal poles exhibited a much wider distribution with high angle of the peaks off the ND. The grains nucleated by GBN, DTN, and PSN did not exhibit preferred growth, and consequently, the texture hardly changed during subsequent grain growth.

Texture Evolution of Al-Zn-Mg-Cu Aluminum Alloy Plate During Cold Rolling

Texture Evolution in an Al-Cu-Mg Alloy During Hot Rolling

Evolution of Goss Texture in an Al–Cu–Mg Alloy During Cold Rolling

Evolution of texture and microstructure of 2E12 aluminum alloy during cold rolling and annealing

Development of Microstructures and Texture During Cold Rolling in AA 7055 Aluminum Alloy

Texture Evolution During Cold Rolling of Dilute Mg Alloys

Textures Variation of 3104 Aluminum Alloy Sheets under Different Rolling Conditions

Microstructure and Texture Evolutions of Aa1050 Aluminum Alloy Cold Rolled to High Strains

Evolution of the Brass Texture in an Al-Cu-Mg Alloy During Hot Rolling

TEXTURE EVOLUTION OF POLYCRYSTALLINE ALUMINUM DURING ROLLING DEFORMATION I.Experimental Study

Texture Evolution of Al-Mg-Li Aeronautical Alloys in In-Situ Tension

Dynamic dissolution and texture evolution of an Al–Cu–Mg–Ag alloy during hot rolling

Slip-induced Texture Evolution of Rolled Mg–6Al–3Sn Alloy During Uniaxial Tension along Rolling and Transverse Directions

Study of Texture in 6016 Aluminum Alloy During Processing

Relevance Between Microstructure and Texture During Cold Rolling of AA3104 Aluminum Alloy

Texture evolution during multi-pass cold rolling and annealing of Ti-2Al-1.5Mn alloy

Texture gradient in rough-rolled plate of aluminum alloy 3104 and its effect on annealing textures evolution after hot compression

Microstructure and Texture Evolution in the Cryorolled CuZr Alloy

Understanding the mechanisms of texture evolution in an Mg-2Zn-1Ca alloy during cold rolling and annealing

Texture Evolution Of 01570 Aluminum Alloy Sheet

Evolution of Microstructures and Textures of High Purity Aluminium During Rolling and Annealing