Abstract:During the production of fiber-reinforced plastics using resin transfer molding (RTM), various characteristic defects and flaws can occur, such as fiber displacement and fiber waviness. Particularly in high-pressure RTM (HP-RTM), fiber misalignments are generated during infiltration by local peaks in the flow rate, leading to a significant reduction in the mechanical properties. To minimize or avoid this effect, the manufacturing process must be well controlled. Simulative approaches allow for a basic design of the mold filling process; however, due to the high number of influencing variables, the real behavior cannot be exactly reproduced. The focus of this work is on flow front monitoring in an HP-RTM mold using phased array ultrasonic testing. By using an established non-destructive testing instrument, the effort required for integration into the manufacturing process can be significantly reduced. For this purpose, investigations were carried out during the production of test specimens composed of glass fiber-reinforced polyurethane resin. Specifically, a phased array ultrasonic probe was used to record individual line scans over the form filling time. Taking into account the specifications of the probe used in these experiments, an area of 48.45 mm was inspected with a spatial resolution of 0.85 mm derived from the pitch. Due to the aperture that had to be applied to improve the signal-to-noise ratio, an averaging of the measured values similar to a moving average over a window of 6.8 mm had to be considered. By varying the orientation of the phased array probe and therefore the orientation of the line scans, it is possible to determine the local flow velocities of the matrix system during mold filling. Furthermore, process simulation studies with locally varying fiber volume contents were carried out. Despite the locally limited measuring range of the monitoring method presented, conclusions about the global flow behavior in a large mold can be drawn by comparing the experimentally determined results with the process simulation studies. The agreement between the measurement and simulation was thus improved by around 70%.

Analysis of Upper- and Lower-Limits of Fill Time in Resin Transfer Mold Filling Simulation

Simulation Of Mould Filling In Rtm Process Using An Unsaturated Flow Layer Technique

Numerical simulation of filling flow of polymer melt in injection molding

Simulation and Experimental Analysis on Non-circular Cross-section Parts Residual Wall Thickness of Water-assisted Injection Molding

Effect on Residual Wall Thickness of Parts with Floating Core Injection of Water-Assisted Injection Molding

Numerical prediction of effect of filling flow on short fiber orientation in injection molding

3D Simulation of Filling Stage of Plastic Injection Molding Based on Improved Finite Volume Method

Numerical Simulation of Two-Phase Flow in Liquid Composite Moulding Using VOF-Based Implicit Time-Stepping Scheme

Simulation method for filling stage in liquid composite molding based on a two-phase flow volume of fluid model

Numerical Simulation of Die-Casting Mold Filling Process Based on Fractional Step Method

Numerical simulation of mold filling of casting with an improved SOLA-VOF method

Optimization of the cycle time in resin transfer molding process by numerical simulation

Precise filling time calculation of thin-walled investment casting in hot mold

Numerical Simulation of Fluid Flow and Heat Transfer During Mold Filling for Die Casting

3D Flow Simulation for Viscous Nonisothermal Incompressible Fluid in Injection Molding

An Improved Mathematical Model to Simulate Mold Filling Process in High Pressure Die Casting Using CLSVOF Method and CSF Model

Unsteady Disposable Flow Tracking Using Discrete Phase Model

Flow Front Monitoring in High-Pressure Resin Transfer Molding Using Phased Array Ultrasonic Testing to Optimize Mold Filling Simulations

Study and Application of Mold Filling Simulation of Shaped Castings

Simplex space-time meshes in thermally coupled two-phase flow simulations of mold filling

Numerical Simulation of Air Entrapment Phenomenon During Mold Filling of High Pressure Die Casting Process